Single Slot DockRead this manual carefully before performing any type ofconnection from the terminal to a host PC using the SingleSlot Dock.The user is responsible for any damages caused byincorrect use of the equipment or by inobservance of theindication supplied in this manual.NOTEDo not attempt to disassemble the Single Slot Dock, as itdoes not contain parts that can be repaired by the user.Any tampering will invalidate the warranty.NOTEThe Single Slot Dock paired with a Falcon X3 mobile computer builds areading system for the collection, decoding and transmission of barcodeddata.The Single Slot Dock is both a USB and a serial communication adapterbetween the terminal and the host computer.The Single Slot Dock also functions as a battery charger, both for theterminal and the spare battery pack. The spare battery can be charged byinserting it into the slot at the back of the dock.Power supply is required for the Falcon X3 to be connected to the dockand for battery recharging operations.Figure 1 –Single Slot Dock General ViewKey:A) Contacts for Falcon X3B) Power on LEDC) Battery charge status LEDD) Spare battery slotE) USB-type B ConnectorF) RS232 connectorG) Power supply connector822001602 (Rev. A) Jan. 2018MOBILE COMPUTER INSERTION/ REMOVALFor correct insertion into the dock, insert the mobile computer from the topof the dock and push it down until the clip of the dock clicks.Figure 2 - Mobile Computer InsertionTo remove the mobile computer from the dock, simply pull it upwards whileholding the dock firmly down.Power SupplyEach dock requires a power supply to be connected to mobile computers.We recommend the power supply already included in the box.-+Figure 3 - Power Supply PolarityTo comply with relevant rules, including but not limited toFCC and CE, the EMI ferrite filter included in the box mustbe used and installed as shown below.WARNINGLED INDICATORSPower LED Status IndicatorColor StatusGreen Dock poweredBattery Charging LED Status IndicatorsColor StatusOff Battery absentRed Battery charge in progressGreen Charge completedRed Blinking ErrorUSING THE SPARE BATTERY CHARGERCorrectly insert the battery pack into the slot: simply press it into the slotuntil the battery latch is automatically closed (figure 4); charging startsautomatically.Figure 4 Figure 5To remove the battery, release the latch on the battery pack (figure 5).FASTENING THE DOCK TO A SURFACETo securely fasten the Single Slot Dock to tables, desks and othersurfaces, and to prevent the dock from moving when you remove thedevice, use the four Velcro dual lock feet provided with the matching dual-lock adhesive pads.Figure 6Remove the protective feet from the dock before attaching the velcro duallock feet.DACBFE G