ModelMDWM100 MONITOR DISPLAY WALL MOUNTTo ensure the correct usage, please read and follow the instruction manual thoroughly. Please store the instructions in a safe place for future reference.3. MOUNT THE MONITOR ASSEMBLY TO THE WALLFig 614Special techniques are necessary for installation of the panel display mount.Manufacturer assumes absolutely no responsibility for injuries and damages that may occur due to improper installation and handling.Projector wall mounting application fig 2All PDR mounts and adapters carry a limited lifetime warranty from ship date against defects in material and workmanship.Check the PDR website for details @ www.PDRmounts.com We are not liable for improper installation that results indamage to mounts, adapters or presentation equipment.Mounts byA division of David Engineering & Mfg. Inc.! Suitable for displays with 75mm &100mm vesa hole pattern! Simple to adjust no tools required! Tilts up and down!Quick monitor removal with exclusive“Bayonet slide system”FeaturesThank you for purchasing the PDR monitor mount.Place the monitor assembly into the bayonet slots on the mounting plate ( small end into large end) fig 6. Tilt and tightenscrews to suite the best viewing angle. To remove slide the unit upwards and out.To ensure customer safety, be sure to decide the installation location so that the strength is sufficient towithstand the weight of both the monitor and the mount.Fully tighten all of the mounting screws as specified in the instructions.Mounting hardwareWall anchors 4 pcsMonitor mounting screw 4 pcsMounting plateRev 062205Tilts up & down