151. DESCRIPTION (page 3)The terminology below will be used repeatedly on the followingpages.1.1 Description of the applianceA1. Water tank lidA2. Tank extraction handleA3. Water tankA4. Cup warmerA5. Boiler outletA6. ON/OFF switchA7. Cup trayA8. Drip tray full indicatorA9. Drip trayA10. Mugs or glasses trayA11. Steam dialA12. Hot water/steam spoutA13. Hot water/steam connection nozzleA14. Cappuccino maker selection ringA15. Hot water/steam connection tube1.2 Description control panelB1. One cup buttonB2. ON light on button (white)B3. Two cups buttonB4. ON light on button (white)B5. Steam buttonB6. ON light on button (white)B7. Descale light (orange)1.3 Description of the accessoriesC1. Filter holderC2. 1 cup filter ( symbol under filter)C3. 2 cup filter ( symbol under filter)C4. Pod filter ( symbol under filter)C5. Measure/presserC6. Water softener filter (*not included, can be purchasedfrom authorised Customer Services)2. FILLING THE WATER TANKPlease note:Before first use, wash all the accessories and water tank withwarm water.1. Extract the tank by pulling it upwards (fig. 1).2. Open the lid and fill the tank with fresh clean water, takingcare not to exceed the MAX level (fig. 2). Put the tank backin the appliance, pressing lightly to open the valves locatedon the bottom of the tank.3. More simply, the tank can also be filled without removingit, pouring the water directly from a jug.Important:Never operate the appliance without water in the tank or with-out the tank.Please note:It is normal for there to be water in the space under the tank.This should therefore be dried regularly with a clean sponge.3. FIRST USEAt first use, rince the internal circuit as follows:1. Turn the appliance on by pressing the ON/OFF switch (fig.3). The appliance performs a self-diagnosis cycle, indicatedby sequential flashing of the three buttons.2. The and lights flash to indicate the applianceis heating up. When the lights stop flashing and remain onsteadily, the appliance is ready for operating the rinse.3. Attach the filter holder to the appliance (fig. 9).4. Place a container with a minimum capacity of 500 mlunder the boiler outlet (A5) (fig. 4) and press thebutton. Repeat this operation 5 times.5. Empty the container and put it under the hot water/steamspout (A12) (fig. 4).6. Turn the hot water/steam dial to the position (fig.5) and deliver to empty the water tank (A3); then turn theknob to the ā position.4. PROGRAMMING THE SETTINGS MENUTo access the menu, make sure the appliance is ready for use,then press and hold the button for 10 seconds until thethree buttons flash in sequence:The appliance is now in programming mode.Set the coffee maker as you wish, then exit the settings menu bywaiting for 15 seconds.Please note:If no selections are made for 15 seconds, the appliance automat-ically exits programming and is ready for use again.4.1 Setting coffee temperatureTo modify the temperature of the water used to make the coffee,proceed as follows:1. Access the settings menu;2. Press the button to enter the coffee temperatureselection mode. The lights corresponding to the currentselection come on: