Decagon Devices Em50G Quick Start Manual
Also see for EM50G: Operator's manualManualQuick start guideQuick start
Em50G QuickStart GuideIntroductionThank you for purchasing an Em50G data logger. The Em50G isa data collection device that will allow you to collect and storedata from up to five Decagon sensors. Collected data are sent tothe Decagon Data Service using cellular/mobile communicationup to six times a day. You can access your data from the DecagonData Service at any time with DataTrac 3 or Em50G Downloader.The Em50G is configured using ECH2O Utility or DataTrac 3.DataTrac 3 is the preferred software package for the Em50G andwill be the primary reference throughout this quickstart guide. Toutilize ECH2O Utility or the Em50G Downloader, please consultthe Em50G user manual.Em50G Logger ConfigurationPlease download the most up to date version of DataTrac 3 soft-ware package from the Decagon website (www.decagon.com)BEFORE you try to configure your Em50G.1. Take the brightly colored card containing your Device ID andput it in a safe place. You will need this number and password todownload your data from the Decagon Data Service.2. To configure the Em50G, directly connect to the Em50Glogger using the included USB cable and launch DataTrac 3.3. Select “connect”. If you are connected to the internet, you’llbe asked to supply your device ID and password.4. Select “configure”.5. Choose the sensor plugged into each port6. Pick your measurement interval. Available measurementintervals are from five minutes to one day.7. Click “Apply”.1. Launch DataTrac 3.2. Click the “setup” menu from the toolbar, then “Create New”,then “Em50G Subscription”.3. You will be asked for the Device ID and password for eachEm50G data logger that you subscribe to. Enter the Device IDand password exactly as they appear on your brightly coloredcard that came inside of your data logger. Both the ID andpassword are case sensitive.4. Pick the appropriate server where your data are stored.Unless Decagon has told you otherwise, your data are beingstored on the “ech2odata.com” server.5. Click “Subscribe”.6. If you have already subscribed to an Em50G data logger, youwill not need to re-subscribe to download the data from the server.Downloading Data Subsequent Times1. Launch Datatrac 3.2. The most recent data from all of your subscribed Em50Gdata loggers will be downloaded automatically.If you have any questions about configuring your Em50G ordownloading data from the Decagon server, please contactDecagon at: 1-800-755-2751 or support@decagon.com.]2365 NE Hopkins CourtPullman, Washington 99163tel: 509-332-2756support@decagon.com13973-03 |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine