Degelman STRAWMASTER X Quick Start Manual

Degelman STRAWMASTER X Quick Start Manual Manual pdf 1 page image

Note: Ensure there is plenty of room behindand to the sides of the Strawmasterbefore backing into field position.4444444555Make sure truss arm LATCHES AREFULLY ENGAGED before loweringharrow sections into field position.5FULLY ROTATE end wheelsBEFORE latching truss arm clamps.5When lowering harrow sections, keepTRAILER HEIGHT AT MAXIMUM.55221BACK-UP SLOWLY/EVENLY to avoidserious damage to transport wheels.2)2)2)2)3)3)4)4)5)5)6)6)7)7)1119)9)7)7)7)7)7)7)7)7) 8)8)Lower disc sections.8)8)61)1)36)6)5)5)5)5)6)6)2)2) REMOVE transport pins/bars and store.1)1) ENSURE jacks are raised prior to backing up.3)3) SLIGHTLY open the transport wheels. (Only 20°)3143437 v0.1QUICK-START GUIDE*for STRAWMASTERX* Refer to operators manual for complete safety and operation info.TOBE ELIGIBLEFORYOUMUSTREGISTERWARRANTYREMEMBER! You must complete ProductRegistration to be eligible for Warranty.A Connect HydraulicsTINE ANGLE..................... Harrow Section Cylinders4DISCS................................ Disc Cylinders3JACK..................................Jack Cylinder6TRANSPORT..................... Transport Cylinders2WHEELS............................ Wheel Height Cylinders1LATCH & ENDWHEEL...... Latch/Steering Cylinders5IMPORTANT: Before working in field, lock the function to avoid accidental operation.B Backing Into Field Position5) As wings are almost fully opened, FULLY ROTATE the endwheels into field position BEFORE completely open.57) Ensure the TRAILER HEIGHT is raised to MAXIMUM andthen lower the harrow sections into field position using theTransport Cylinders.126) Activate the LATCH hydraulics to fully secure the truss armsinto place. Make sure truss arm LATCHES ARE FULLYENGAGED before lowering harrow sections into field position.IMPORTANT: To prevent serious damage, ensure bothlatches have fully engaged and then LOCK-OUTthe Latch & Endwheel circuit before operating. 5OpenOpenClosedClosed9) Adjust Tine Angle, Trailer Heightand Disc settings.8) Lower the disc sections using the Disc Cylinders.4) Back-up slowly. The wings will open up. Ensure there is lots ofroom behind and to the sides. Back-up evenly so you don’tdamage the transport wheels.IMPORTANT: Be sure to back-up evenly to avoidserious damage to the transport wheels.2) Remove the front Center Beam Transport Pins (2),Cylinder Lock Bars (2), and Endwheel Transport Bars (2)and place in storage locations.StoreStoreStoreStoreRemoveRemoveCylinderCylinderLockLockRemoveRemoveTransport PinTransport PinStoreStoreRemoveRemoveTransportTransportBarBar3) Activate the steering cylinders to slightly angle open thetransport wheels, but no more than 20º.20ºMAX51) Raise hydraulic jack after connecting to the tractor.63

/ 2

Related manuals for Degelman STRAWMASTER X