Dell 3000CN Setup Manual

Also see for 3100cn - Color Laser Printer: Owner's manual User guide

Dell 3000CN Setup Manual Manual pdf 1 page image

Connect the power cable into the printer, and plug it into the electricalwall outlet. Turn on the printer.The toner cartridge carrier rotates and then stops. After confirmingthe Insert Black Toner (K) message, open the front door.Hold the tape on the protective cover and gently pull it forward toremove the cover from each cartridge slot. You only have to remove thecover from each toner cartridge slot the first time you use your printer.Toner will be present on the roller.Make sure the color of the toner cartridge matches the slot on thetoner cartridge carrier. The order is K, Y, M, C. Gently shake thecartridge to distribute the toner evenly.Lift the tab up 90 degrees and pull the toner seal straight off, keeping itparallel with the toner cartridge.To insert the toner cartridge, face the label on the cartridge to the frontand align it with the arrows on the printer. Guide the cartridge until itsnaps into place and then push down the handhold to lock the cartridgein place.Close the front door. The toner cartridge carrier rotates to the nextempty slot. When the color of the newly inserted cartridge appears onthe display, followed by the Insert message, insert the next tonercartridge. Repeat steps 6-11 until all cartridges are installed.Open the front door, then lift and push back the top cover.Take the drum cartridge out of the box, and then remove the protectivesheet.To insert the drum cartridge, push up the lever on the right side of theprinter.Setting Up Your Printer |1Unpack the printer and tray module. Remove any tape from the printer and tray module, andremove the protective seal from the operator panel.For the Dell Laser Printer 3000cn, the part marked with in the above illustration is notprovided with the printer.To install the standard tray module, place the tray module on top of the table or printer cabinetwhere you plan to use the printer. The three tabs, round peg thumbscrews, and square holeshelp you position the tray module so the edges are aligned properly. Set the printer on top ofthe tray module. Make sure the printer is securely in place.For the Dell Laser Printer 3000cn, the procedures in step 2 and 3 are required if you purchasethe optional 250-sheet tray module.Remove the tray. There are two knobs located under the top plate of the tray module. Reach intothe tray module and push up the knobs once, then turn the knobs counterclockwise asillustrated to attach the tray module to the printer.Open the front door, remove the spacer, and then close the front door.2 3 45CAUTION: The printer requires at least twopeople to lift it safely.6 7 910 11812 13 14Continued to back page / ➔CAUTION: When removing the tonerseal, a small amount of toner leakagecould occur.CAUTION: Before you set up and operate your Dell™ printer, read and follow the safety instructions in your Owner’s Manual.• These instructions and illustrations are based on Dell Laser Printer 3100cn.• The standard 250-sheet tray module is only available for Dell Laser Printer 3100cn. The procedures in steps 2 and 3 are not requiredfor Dell Laser Printer 3000cn.• The optional multi protocol card is only available for Dell Laser Printer 3100cn.• The tray module in steps 17 through 21 is optional for Dell Laser Printer 3000cn.T6131A00

/ 2

Related manuals for Dell 3100cn - Color Laser Printer