Dell™ E772f Color MonitorQuick Setup GuideSafety InstructionsObserve the following safety guidelines when connecting and using your monitor:• Be sure that your monitor is electrically rated to operate with the AC power available in your location.• Locate your monitor near an easily accessible electrical outlet.• Place the monitor on a solid surface and treat it carefully. The screen can be damaged if dropped, sharplyhit, or touched with a sharp or abrasive implement.• Put your monitor in a location with low humidity and a minimum of dust.• Never use your monitor if the power cable has been damaged. Do not allow anything to rest on the powercable, and keep the cable away from where people could trip over it.• Never insert anything metallic into the monitor openings. Doing so may create the danger of electric shock.• To avoid electric shock, never touch the inside of the monitor. Only a qualified technician should open themonitor’s case.• Be sure to hold the plug, not the cable, when disconnecting the monitor from an electrical outlet.• Openings in the monitor cabinet are provided for ventilation. To prevent overheating, these openingsshould not be blocked or covered. Also, avoid using the monitor on a bed, sofa, rug, or other soft surface.Doing so may block the ventilation openings in the bottom of the cabinet. If you put the monitor in abookcase or some other enclosed space, be sure to provide adequate ventilation.• Do not expose the monitor to rain or use it near water. If the monitor accidentally gets wet, unplug it andcontact an authorized dealer immediately. You can clean the exterior of the monitor with a damp clothwhen necessary, but be sure to unplug the monitor first.• If your monitor does not operate normally—in particular, if there are any unusual sounds or smells comingfrom it—unplug the monitor immediately and contact an authorized dealer or service center.Connecting Your Monitor to a Computer1. Turn off your computer and unplug your computer’s power cable.2. Connect the blue connector of the monitor’s signal cable to the blue video connector on the back of yourcomputer. Tighten the connector screws finger-tight. Do not overtighten.3. Fully insert the monitor power cable into the power port on the back of the monitor.4. Plug the power cables of your computer and your monitor into a nearby electrical outlet.5. Turn on your computer and monitor. If the monitor does not display an image, refer to the troubleshootingsection of this guide.Dell E772f Color Monitor Quick Setup Guide 1