Dell Networking 207 Series Access PointsRegulatory Compliance and Safety Information Guide0511921-01 | October 2016 1IntroductionThis document contains domestic and international regulatory compliance and safety information for Dell Networking 207 Series access points (W-AP207 andW-IAP207). To ensure that this device complies with the regulatory standards for your region, please refer to the sections below. Electrical and Environmental Specifications Regulatory Information Proper Disposal of Dell EquipmentElectrical and Environmental SpecificationsFor additional specifications on this product, please refer to the product data sheet at dell.comElectrical Ethernet: One 10/100/1000 Base-T auto-sensing Ethernet interface (RJ-45) Power: Maximum power consumption (excluding USB):13.5W (PoE) or 12W (DC) Direct DC source: 12Vdc nominal, +/- 5% Power over Ethernet (PoE): 802.3af complaint source Connect only to IEC 60950-1 or IEC 60601-1 3rd edition products and power sources.Environmental Operating: Temperature: 0°C to +50°C (+32°F to +122°F) Humidity: 5% to 93% non-condensing Storage and transport Temperature: -40°C to +70°C (-40°F to +158°F)Regulatory InformationThe following regulatory model names apply to the 207 Series access points: W-AP207/W-IAP207: APIN0207CAUTION: All Dell access points should be professionally installed by a certified technician. The technician is responsible for ensuring thatgrounding is available and meets applicable national and electrical codes.ATTENTION: Tous les points d'accès Dell doivent impérativement être installés par un professionnel agréé. Ce dernier doit s'assurer quel'appareil est mis à la terre et que le circuit de mise à la terre est conforme aux codes électriques nationaux en vigueur.NOTE: If a power adapter other than the Dell-approved adapter is used in the US or Canada, it should be NRTL listed, with an output rated 12Vdc,minimum 2A, marked “LPS” and “Class 2”, and suitable for plugging into a standard power receptacle in the US and Canada.NOTE: For country specific restrictions and additional regulatory and safety guidelines, refer to theDell Networking W-Series Safety,Environmental and Regulatory Information document included with Dell controllers and Instant access points.CAUTION: Access points are classified as radio transmission devices, and are subject to government regulations of the deploying country. TheNetwork Administrator(s) are responsible for ensuring that the configuration and operation of this equipment is in compliance with theircountry’s regulations. Specifically, access points must use channel assignments appropriate to the locale in which the access points will beused. For a complete list of approved channels in your country, refer to the Downloadable Regulatory Table (DRT) release notes at dell.com