w w w . d e l l . c o m | s u p p o r t . d e l l . c o m142536w w w . d e l l . c o mw w w . d e l l . c o mSetting Up Your Network Management CardVerify the package contents1. Network Management Card2. Serial cable3. Setup instructions4. Safety, Enviromental, andRegulatory InformationInsert and secure the cardwith the retaining screwsNote the MAC address on the cardConnect an Ethernet cable to the cardand to the network (not supplied)NOTE: You can set the card parametersvia the Settings Port even if the network isnot connectedRemove the cover from theUPS communication bayWait approximately twominutes until the UPS DataLED flashes regularly,indicating normal operationACT 100M UPS Data RS232Ethernet Port (10/100BaseT)ACT LED (green) Off Card is not connectedto the networkOn Card is connectedto the network,but no activityFlashing Port is sending/receiving100M LED (orange) Off Port is operatingat 10 Mbits/sOn Port is operatingat 100 Mbits/sSettings PortUPS Data LED (green) Off Card is startingOn Card is communicatingwith the UPSFlashing Normal operation;communication withthe UPS is operationalRS232 LED (orange) On Configuration menuis activatedOff Normal operation;Configuration menuis not activatedUPS Data LED flashingMAC addressAbout Your Network Management Card1. Ethernet port (10/100BaseT)2. ACT LED (green)3. 100M LED (orange)4. Settings port5. UPS Data LED (green)6. RS232 LED (orange)231123456Safety, Environmental, andRegulatory Informationbook.book Page 1 Monday, May 5, 2008 11:15 AMEXAMPLE 4