Dell SPR-RK3-MNT Installation Manual

Dell SPR-RK3-MNT Installation Manual Manual pdf 1 page image

Dell Networking SPR-RK3-MNTInstallation Guide0511709-02 | April 2015 1This document provides installation instructions for standard front-rack mounting the Dell W-7024/W-7205controller in a standard two-post 19" Telco rack using the SPR-RK3-MNT accessory kit.The W-7024/W-7205 controller is referred to as "device” in rest of the document.Package Contents Two rack mount brackets Eight M4 x 8 mm Phillips Flat Head screws Four M6 x 15 mm Phillips Pan Head screws Four M6 cage nuts Four M6 clip nuts Installation Guide (this document, printed)Standard Rack Mount InstallationThis option allows mounting the device from the front in a standard two-post 19” Telco rack.Required Tools and Equipment Two rack-mount brackets Eight M4 x 8 mm Phillips Flat Head screws Four M6 x 15 mm Phillips Pan Head screws Four M6 cage nuts (optional) Four M6 clip nuts (optional) Suitable screwdrivers (not included in this kit)Installation StepsTo install the device in a two-point 19” (48.26 cm) rack system:1. Place the mounting brackets over the mounting holes near the front on either sides of the device (see Figure1).NOTE: Some racks require screws that differ from those included with the device. Confirm that you have the correct screwsbefore installing the device.CAUTION: Each device should have its own mounting equipment. Do not place other networking equipment directly on top of amounted device. Failure to do so can result in damage to the device.NOTE: The figures in this document illustrate the installation procedure for the W-7205 controller. The same installation procedureapplies to the W-7024 controller.

/ 4

Related manuals for Dell SPR-RK3-MNT