![Delta-Therm PCK-C6 Installation Instructions Manual Manual pdf 1 page image](https://manuals-archive2.s3.amazonaws.com/3023384/7d7c5896c86790126f9d9fc2c25695591f.jpg)
WARNING: This kit and the cable used with it mustbe installed by a qualified electrician. All assembly,installation, and test instructions must be followed.Improper installation can result in property damage,serious injury, and/or death due to electric shock and fires.Please call Delta-Therm Corporation at 1-800-526-7887with any installation or operating questions.DELTA-THERM Corporation, 6711 Sands Road Suite A, Crystal Lake, IL 60014 (847) 526-2407 Fax (847) 526-4456 (800) 526-7887A. Heat Shrink Sleeve .375” x 6” (1 x 15cm)B. Cable Connector AssemblyC. Standoff BracketD. High Temp Fiberglass Tape (60" x 1/2")E. Heat Shrink Sleeve .5” x 1.5” (1 x 11cm)F. Ground ScrewG. Closed-End Crimp Connectors (2)H. Ring ConnectorI. .75” Sealing LocknutJ. Heat Shrink Sleeve .25” x 1.5” (.5 x 11cm)K. Heat Shrink Sleeve .125” x 2.5” (.3 x 6cm)L. Caution Labels (6) SmallTOOLS NEEDED• Crimping Tool• Wire Stripper/Cutter• Utility Knife• Flat-Blade Screwdriver• Needle-Nose Pliers• Adjustable Wrench• Heat Gun (750F)• Measuring TapeAB CDFE GHIJ KLInstallation InstructionsPCK-C6Power Connection Kit:CO Series for Pipe TracingCONNECTINg TO POwERFor braided Cable1. Remove 6" (15cm) of any optional overjacket.2. Push the braid back to loosen it.3. Approximately 6" (15cm) from the end of thecable, spread the braid strands to create anopening.4. Bend the cable at the opening, then pull the cablethrough the opening to free the braid.5. Twist the braid into a cold lead, then trim the coldlead to remove the tapered end.Detail 1.6. Insert the cable through the connector cap, the glandwasher, and the grommet, leaving 4” (10cm)exposed from the end of the rubber grommet.Detail 2.continued....