Denali CANsmart GEN II Instruction Manual

Also see for CANsmart Controller GEN II: Instruction manual Instruction manual Instruction manual

Denali CANsmart GEN II Instruction Manual Manual pdf 1 page image

Instruction Rev000 mm 10 20 30 40 50 60 70 80 90Thank you for choosing DENALIWe know you would rather be riding your bike than wrenching on it, so we go the extramile to make sure our instructions are clear and as easy to understand as possible. Ifyou have any questions, comments, or suggestions don’t hesitate to give our expertsa call at 401.360.2550 or visit WWW.DENALIELECTRONICS.COMPlease Read Before InstallingDENALI products should always be installed by a qualified motorcycle technician. Ifyou are unsure of your ability to properly install a product, please have the productinstalled by your local motorcycle dealer. DENALI takes no responsibility for damagescaused by improper installation. Caution: When installing electronics it is extremelyimportant to pay close attention to how wires are routed, especially when mountingproducts to the front fender, front fork, or fairing of your motorcycle. Always be sureto turn the handlebars fully left, fully right, and fully compress the suspension toensure the wires will not bind and have enough slack for your motorcycle to operateproperly.Installation TipsWe strongly recommend using medium strength liquid thread locker on all screws andbolts. It is also important to ensure that all hardware is tightened to the proper torquespecifications as listed in your owner’s manual. For included accessory hardwareplease refer to the default torque specifications provided below. Inspect all hardwareafter the first 30 miles to ensure that proper torque specifications are maintained.Hardware Sizing GuideNot sure what size bolt you have? Use this ruler to measure screws, bolts, spacers, etc.Remember, the length of a screw or bolt is measured from the start of the “mountingsurface” to the end of the screw, so only include the screw head when measuringcountersunk screws.M3 10.0 in-lbs - 1.0 NmM4 23.0 in-lbs - 2.5 NmM5 44.5 in-lbs 3.5 ft-lbs 5.0 NmM6 78.0 in-lbs 6.5 ft-lbs 9.0 NmM8 - 13.5 ft-lbs 18.0 NmM10 - 30.0 ft-lbs 41.0 NmM12 - 52.0 ft-lbs 71.0 Nmin-lbs ft-lbs NmBolt Size0in 1 2 3What’s In The Box?DENALIELECTRONICS.COMInstruction Manual(a) CANsmart™ Controller..........................................................Qty 1(b) 3-Pin 5ft Horn Extension.......................................................Qty 1(c) 3-Pin 5ft LED Light Extension.................................................Qty 2(d) 3-Pin Brake Light Wiring Adapter............................................Qty 1(e) Zip Tie...............................................................................Qty 4(f) Adhesive Dual Lock..............................................................Qty 1(g) USB to Micro USB Programming Cable.....................................Qty 1Kit Contents(b)(c)(f)(d)(e) (g)(a)GEN II CANsmart™ ControllerDNL.WHS.23800Harley-Davidson Pan America 1250Harley-Davidson Pan America 1250 Special