Dension Power Booster General Installation Manual

Also see for Power Booster: General installation guide

Dension Power Booster General Installation Manual Manual pdf 1 page image

Power BoosterGeneral Installation Guidev.1.1Instructions manualIPod Power Booster (IPB) is an optional accessory for Ice > Link ONE, Gateway100/300 and 500 devices to provide increased power output (up to 1A) for iPhone3Gs (with 4.x iOS) and iPhone 4G.Installation steps:Always make sure that the ignition key is removed from the car, the radio isswitched off and that you have the security code of the head unit (radio)available (if applicable).1. First, carefully remove your vehicle's existing factory fit head unit as per thefactory instructions (or check the installation manual of your device for furtherdetails) and using the correct tools in order to get access to your Densionhardware2. Disconnect the Molex connector (depending on your device type this can be(4, 10, 12 or 18 pin) from the Dension device3. Connect the IPB male Molex connector to the Dension device and connect theoriginal (car harness) Molex to the female end of the Power Booster4. Remove the round iPod dock or cradle (9 pin) connector from the device andreplace it with the IPB’s round dock connector5. Connect your iPod cable round connector to the IPB6. Test your system functionalities7. Finally when you have tested everything, refit your Head Unit (Take care not totrap any wires or the Dension product and mount the modules away from theheat and damp surfacesAll manuals and user guides at all-guides.comall-guides.com

/ 2

Related manuals for Dension Power Booster