Duracell Powerpack Pro 1300 Manual
Also see for Powerpack Pro 1000: User manual
1. Charging/recharging your PowerpackIMPORTANT - BEFORE YOU STARTPlease fully charge your Powerpack before using it for the first time. It isalso recommended to fully recharge your Powerpack after each use.1. Locate the AC charging cord stored in the compartment near thePowerpack’s handle.2. Plug the cord into the Powerpack’s AC charging input.3. Plug the other end of the cord into an AC wall outlet.4. Charging time is approximately 24 hours from a fully discharged batteryto a full recharge.The Battery Status LED will turn green when fullycharged.5. It is safe to leave the Powerpack plugged into an AC wall outlet so that itis always fully charged and ready when you need it. The charging currentwill automatically reduce to “maintenance” mode once the Powerpackhas been fully charged.123Powerpack Charging: Important Notes• Do not operate DC appliances with the Powerpack Pro while thePowerpack is being recharged with the AC cord. The AC cord may bepermanently damaged if 12V DC appliances are operated while the ACcord is connected.• If you keep the Duracell ® Powerpack Pro in storage, the battery willdischarge over time. Remember to recharge the battery every threemonths to keep the Powerpack operational.• If the voltage in your wall outlet is less than 120V AC, it may take morethan 24 hours to fully recharge the powerpack. If, after 24 hours ofcharging, the Battery Status LED remains red, continue to charge the unitfor another 12 hours. The unit will be ready for use even if the BatteryStatus LED remains red.2. Checking the battery level1. Push the Battery Level button on thefront panel.2. The LED gauge will display the currentlevel of available battery power:• Fully charged: All LEDs (twogreen, one yellow and one red) areilluminated when the battery is full.• Completely discharged: Only thered LED is illuminated when thebattery is completely empty.Battery Level: Important NotesBattery fuel gauge status is only accurate when the Powerpack hasbeen disconnected from all appliances and all charging sources for15 minutes.• Some appliances may be difficult or impossible to operate from thePowerpack if they have a high surge rating or are not suitable for usewith the Powerpack.Trouble AppliancesTo avoid damage to your AC appliance, the Powerpack is notrecommended for use with the following:• Electronics that modulate RF (radio frequency) signals on the AC line.• Speed controllers found in some fans, power tools, kitchen appliances,and similar appliances.• Some chargers for small rechargeable batteries can be damaged.• Metal halide arc (MHI) lights can be damaged.High Surge Appliances“Surge” power is the initial amount of power required to start anappliance.• Appliances such as televisions and appliances with motors consumemuch more power than their average (continuous use) rating when theyare first switched on. This may exceed the capabilities of the Powerpackand trigger the safety overload shutdown circuit.3. Using the LED light21 1. Push the “Emergency Light” button toturn on the LED light.2. Gently swivel the lens up and down toaim the light beam.3. Push the “Emergency Light” buttonagain to turn off the light.4. Using the USB portsThe Powerpack’s dual USB ports can charge two USB devices at once, sup-plying up to 2.4 total Amps of current.1. Connect your USB device (smartphone, tablet, etc.) to your own USBcable.2. Plug the USB cable into the Powerpack’s USB port.3. Push the “USB On/Off” button.4. Charging will begin. The Powerpack will adjust the amount of currentsupplied to each device based on its requirements.5. Push the “USB On/Off” button again when done.1235. Using the AC outletsThe Powerpack’s dual USB ports can power two AC appliances at once, up toa total of 240W for Powerpack Pro 1000, or 480W for Powerpack Pro 1300.For best results, ensure that your Powerpack is fully charged before using theAC outlets.1. Press the AC outlet ON/OFF Switch to the ON position.2. Open the protective cover on the AC power outlet and plug the ACappliance in.3. Fully recharge the Powerpack as soon as possible after each use.4. In the event of an overload, low battery voltage or overheating, thePowerpack automatically shuts down.21AC Appliances: Important NotesUnderstanding appliance wattage• AC appliances are rated by how much electrical power (in watts)they consume. The fewer watts an AC appliance uses, the longer thePowerpack will operate before recharging is required.6. Using the 12V DC power outletThe Powerpack can operate 12V DC appliances (such as those that pluginto a vehicle’s lighter socket) that draw 20 Amps of power or less.1. Open the protective cover on the DC power outlet and plug yourappliance into the port.2. Turn the appliance on (if required). The Powerpack will automaticallysupply power to your appliance.13. Fully recharge the Powerpack as soon as possible after use.12V DC Outlet: Important NotesBattery power drain• As the DC power outlet is internally wired directly to the Powerpack’sbattery, it does not automatically switch off. Check the battery statusperiodically to prevent total battery discharge.• Extended operation of a 12V DC appliance may result in excessivebattery discharge.High-consumption DC appliances• If your 12V DC appliance draws more than 20 Amps, the Powerpack’sinternal circuit breaker shuts off the power to your appliance. Youwill not be able to use this appliance with the Powerpack. If shutoffoccurs, unplug your appliance. The Powerpack’s internal circuit breakerautomatically resets after a few seconds.Powerpack Pro 1000 / Powerpack Pro 1300A. Features• Powers 115 V AC appliances• Powers 12V DC appliances• Powers 5 V USB devices• Jump starts vehicle engines• Provides lighting for emergency use• Inflates vehicle tires and small sports equipment• Reflective trim provides high visibility at nightComprehensive protectionReverse polarity protectionThe reverse polarity LED will light up when you connect the wrongterminals. The reverse polarity alarm will also beep.Over current protectionThe built in charger protects against over current when it isrecharging.Over voltage protectionThe built in charger will shut off when the voltage reaches the limit.B. What’s Included1. Powerpack Pro 2. AC charging cord 3. Inflation accessories1212 3 |
Related manuals for Duracell Powerpack Pro 1000
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine