Dynex DX-ECFW Quick Setup Manual

Also see for DX-ECFW: User guide Faq User guide Quick setup guide User manual

Dynex DX-ECFW Quick Setup Manual Manual pdf 1 page image

DX-ECFW FireWire 800 ExpressCard AdapterFeatures• Fully compliant with ExpressCard specifications• Compatible with FireWire 800 (IEEE 1394b) and FireWire 400 (IEEE 1394a)devices including DV camcorders, CD-RW and DVD drives, portable harddrives, digital cameras, VTRs, digital TVs, and other audio and video devices• Provides one 9-pin FireWire 800 and one 6-pin FireWire 400 port for multipledevice connections• Supports IEEE 1394b serial bus data transfer rates of 100, 200, 400, and800 Mbps• Compliant with IEEE 1394b and backward compatible with IEEE 1394a-2000and IEEE 1394-1995 standards• Hot-swappable—allows you to connect and disconnect devices withoutturning off the computerPackage contents• Dynex DX-ECFW FireWire 800 ExpressCard adapter• Quick Setup GuideSystem requirements• One available ExpressCard 1.34-inch (34 mm) or 2.13-inch (54 mm) slot• Windows 7, Windows Vista, Windows XP, Windows 2000, or Mac OS X v10.4.xor higherInstalling the adapter• Slide the adapter into your notebook’s ExpressCard slot until it is firmlyseated. Your operating system automatically detects the adapter when it isinstalled, then uses the correct driver. No separate driver installation isneeded. Mac OS X (v10.4 or later) users will need to restart their computerafter the driver is installed.Use Device Manager to verify that the adapter is installed. SeeTroubleshooting Step 2 for instructions.Troubleshooting1 How do I use the power jack on the adapter?• Most FireWire devices have their own power supply. 12V/2A DC adapter(not included) is required to use with any FireWire devices without anAC power adapter.2 My computer isn’t recognizing the FireWire adapter.• Remove the adapter from the ExpressCard slot of your laptop andre-insert it into the ExpressCard slot until it’s firmly seated.• Repeat the device driver installation procedures.• Check the Device Manager to see if the device is recognized.1 Click Start, right-click My Computer (Windows 2000 & XP) orComputer (Windows Vista & 7), then click Properties.2 Click Device Manager.3 Double-click IEEE 1394 Bus host controller.• For Windows 2000 & XP:• Click OHCI Compliant IEEE 1394 Host Controller and make surethat there are no conflicts. Conflicts are indicated by an entry witha red X or a yellow exclamation point (!). If a conflict is found, seeWindows Help for more information.• For Windows Vista & 7:• Click LSI 1394 OHCI Compliant Host Controller and make surethat there are no conflicts. Conflicts are indicated by an entry witha red X or a yellow exclamation point (!). If a conflict is found, seeWindows Help for more information.4 To update the adapter driver, right-click the adapter, click UpdateSoftware Driver, and follow the on-screen instructions to updatethe driver.Quick Setup GuideExpress Card interfaceFireWire 400 portDC power jack FireWire 800 portDX-ECFW_10-0792_QSG_V3_EN.eps 1 10/29/2010 2:58:41 PMDX-ECFW_10-0792_QSG_V3_EN.eps 1 10/29/2010 2:58:41 PM

/ 2

Related manuals for Dynex DX-ECFW