1. InventoryBefore beginning installation, inventory yourJFX100 bracket kit to items listed.Item Qty DescriptionA 1 Bracket/WallmountB 1 Plate/Top Hat SpanC 2 Screw, 3/8-16 x 1-1/2 inch LgD 2 Rubber WasherE 2 Lock WasherF 2 Flat WasherWarning: Installation should only be done by an experienced technician. Improper installationmay cause damage, serious injury, or death.2. Mounting the BracketDue to various construction methods andmaterials, the hardware for securing the bracketto the mounting surface is not supplied.It is recommended that you consult a buildingprofessional for the proper mounting hardwarebefore mounting the bracket (A). When horizontallymounting an enclosure make sure the fouropenings in the bracket arms face upward.3. Installing the Plate/Top Hat SpanRemove the 2 screws (G) on each side of the tophat. Fit the span plate (B) into the recess andsecure it to the cabinet with the same 2 screws(G) just removed.4. Removing the Threaded PlugIn the center of the top fly mount is a3/8-16 plug (H). Remove it using a Phillips headscrewdriver.5. Choosing which Slot to UseThere are two slots in the bracket arm. Theforward slot is used in these instructions. Theforward slot is intended for use with weatherprotected cabinets. The back slot is intendedfor indoor installations where cable connectionsare made to the terminal strip.Installation InstructionsJFX100 Bracket KitABDC EFBECDF(2) SCREWS (G) ORIGINALLY INSTALLEDIN CABINET TO BE REUSED(1/4-20 X 1-1/4 LG PH FHMS)HAGG