CAM-INT-00 Internal IP CameraIntroductionThe CAM-INT-00 is a 1 / 2.7” Mega-Pixel CMOSsensor IP camera with a built-in web server. Theuser can view real-time video via IE browser. Itsupports H.264, and M-JPEG video compression,providing smooth and high video quality.Supports Wired Ethernet connections and Wi-Ficonnectivity with a user friendly interface, it is aneasy-to-use IP camera for security applications.The camera support a web interface that allowsauthorised users access the camera menus andchange settings.The only configuration of the Camera that theInstaller is required to do is set the IP addressand/or Wi-Fi settings and also set up theimage/focus.The panel will configure all required settings forvisual verification of the camera once the IPaddress of the camera has been entered in to thepanel.Package contents:1 x internal IP camera1 x bracket1 x screw package1 x quick installation guideNote: It is recommended you follow theseinstructions and configure the device beforemounting it.This product must be installed by qualified servicepersonnel.Installing the unitConnectionsThe camera connectors are as below.Connect the power and the Ethernet cable to thecamera and set it according to your networkenvironment.Mounting BracketUse the screws to lock the bracket to the wall orceiling, and then connect the camera to thebracket. There’s a knob on the back of thebracket, after the knob is loosened you can adjustthe angle of camera; tighten it to fix the angle.Adjust focusUse the rotary dial to adjustfocus until the image is clear.Power OverEthernet (Optional)802.3af, 15.4W PoE Switch is recommendedPower over Ethernet (PoE) is a technology thatintegrates power into a standard LANinfrastructure. It allows providing power to anetwork device, such as an IP phone or anetwork camera, using the same cable as thatused for network connection. It eliminates theneed for power outlets at the camera locationsand enables easier application of uninterruptiblepower supplies (UPS) to ensure an operation of24 hours a day, 7 days a week.IP assignmentBy default the camera will be configured toobtain a DHCP IP address when plugged into aDHCP enabled router.Alternatively the camera can be connected to aWPS enabled router. The WPS learn mode isinitiated by pressing the WPS button until theblue light is flashing, once the camera hassynced with the WPS enabled router then theblue light with remain on.If the camera does not detect a DHCPconnection then it will switch to a fixed IPaddress of 192.168.0.200.Connect to WiFi usingWPS1. Locate WPS button on the Wi-Fi router2. Depending on the make and modelthis may start to flash. Press toactivate the WPS feature (consultrouter manufacturer for details onWPS function)3. Locate the WPS button on rear ofcamera4. Press and hold WPS button till the blueLED starts to flash. When the camera and