MN05401004E 1español englishfrançaisdeutschitalianoOperating InstructionsElectronic Posi tion Indicatorand Electronic Frequency MeterE5024E04321.1 Safety instructions and warningsOnly use this display– according to its intended purpose– if its technical condition is perfect– adhering to the operatinginstructions and the generalsafety instructions.1.2 General safety instructions1. Before carrying out any installation or mainte-nance work, make sure that the power supplyof the digital display is switched off.2. Only use this digital display in a way accordingto its intended purpose:If its technical condition is perfect.Adhering to the operating instructions and thegeneral safety instructions.3. Adhere to country or user specific regulations.4. The digital display is not intended for use inareas with risks of explosion and in thebranches excluded by the standard EN 61010Part 1.5. The digital display should only operate if it hasbeen correctly mounted in a panel, in accor-dance with the chapter “Technical data”.1.3 Use according to the intendedpurposeThe digital display may only be used as a panel-mounted device. Applications of this product maybe found in industrial processes and controls, inmanufacturing lines for the metal, wood, plastics,paper, glass, textile and other processingindustries.Over-voltages at the terminals of the digital dis-play must be kept within the limits in Category II.If the digital display is used to monitor machinesor processes in which, in case of a failure of thedevice or an error made by the operator, theremight be risks of damaging the machine or caus-ing accidents to the operators, it is your respon-sibility to take appropriate safety measures.1.4 Description• 6-digit position indicator and frequency meter• Red LED display, character height 8 mm[0.31 in.]• Display range -199 999 – 999 999• Lead zero blanking• Programming via two setting keys on the frontside• During programming, the display guides theuser with text prompts• Position indicator operating modes– Count input INP A + count direction inputINP B (Cnt.Dir)– Differential count INP A - INP B (up.dn)– Totalizing INP A + INP B (up.up)– Count Up/Down INP A 90° INP B x 1(quad)– Count Up/Down INP A 90° INP B x 2(quad2)– Count Up/Down INP A 90° INP B x 4(quad4)• Frequency meter– Frequency input INP C– Value conversion and display in 1/s or1/min2. InputsINP ADynamic count input.INP BDynamic count input.INP CDynamic frequency input.!