INS #Installation Instructions Model# CK4-120NOModel# CK4-277NOControlKeeper 4General InformationThe ControlKeeper 4 model is shipped in one package andis configured with either a 120V or a 277V transformer. Itis factory configured with Normally Open relays. Pleaserefer to your order information to determine which modelyou have purchased.Getting Started1. Do not discard these installation instructions. Pleasekeep for future reference and operation information.2. Always disconnect all power before wiring.3. Use only as intended and at the listed voltage.4. All installation and service must be performed byqualified personnel or service technicians.5. Install in accordance with the National Electrical Codeand any other codes which may apply.6. Installation and wiring information contained in thisdocument is based on industry-accepted standardsand practices. If conflicts exist between theseinstructions and any applicable codes or ordinances,please contact Greengate before proceeding with theinstallation.7. High voltage is present inside the enclosure. Useextreme caution when performing maintenance onthis equipment. Failure to follow this warning andproper safety procedures could result in severe injuryor death, and/or damage to the equipment.8. Document all wiring and device terminations andlocations so that devices can be properly configuredand programmed for operation.Mounting the Cabinet1. Choose a dry location on a firm surface convenient tothe circuits being controlled. Allow full clearance forthe door of the enclosure to open fully.2. Mount the ControlKeeper 4 cabinet using theholes provided in the back of the enclosure. It isrecommended that the panel be mounted vertically.3. All line voltage conductors must enter the cabinet onthe right side of the enclosure.4. All low voltage conductors must enter the cabinet onthe left side of the enclosure.5. Remove all debris and metal shavings fromthe enclosure before applying power to theControlKeeper 4.Figure 1. ControlKeeper 4 EnclosurePower Supply WiringThe ControlKeeper 4 is factory configured with eithera 120V or a 277V transformer. Transformer voltages arecolor coded. It is recommended that a dedicated branchcircuit with circuit protection be used for power supplywiring.1. Connect neutral wire to the white wire.2. If the transformer is a 277V model, connect orangewire to a 277V circuit. If the transformer is a 120Vmodel, connect black wire to a 120V circuit.Bring low voltage inthrough the Left Sideof the EnclosureBring high voltage inthrough the Right Sideof the Enclosure