Publication Number AD05006002E Page 1Application of SmartWire-DT®How to use SmartWire-DT on EtherNet/IP® andModbus TCPApplicationThe EU5C-SWD-EIP-MODTCP Ethernet to SmartWire-DT gateway supportsboth EtherNet/IP and Modbus TCP Ethernet protocols. This allows anyEtherNet/IP or Modbus TCP master to fully control and monitor all devices on theSmartWire-DT network. Devices that may be connected to SmartWire-DT includeXT contactors and starters, M22 pushbuttons and pilot devices and digital andanalog input and output modules. SmartWire-DT dramatically reduces wiring timeand reduces panel complexity by consolidating complex circuit wiring into asingle, durable 8-pole cable.OverviewThe purpose of this application note is to demonstrate how to configure aSmartWire-DT system and how to set up an Ethernet master to control andmonitor all devices on that SmartWire-DT system. A Rockwell® CompactLogix®controller will be used to demonstrate EtherNet/IP connectivity to SmartWire-DTand an Eaton ELC-PV controller with Modbus TCP Ethernet master will be usedto demonstrate Modbus TCP connectivity to SmartWire-DT. XT starters and M22pushbuttons and pilot devices will be connected to the SmartWire-DT network.Configuring the SmartWire-DT System using SWD-Assist®SWD-Assist is a software tool for configuring a SmartWire-DT system. Thissoftware allows the user to fully build and configure a system offline without anyhardware present; then download to the system once the hardware is in place.Or, connect the software to a wired and powered SmartWire-DT system and usethe auto-configuration feature to map the data for all connected devices into theSmartWire-DT Ethernet gateway (EU5C-SWD-EIP-MODTCP).