Eclipse 22716EDR3 Installation Instructions Manual
Also see for 22716EDR3: Manual
 |
Cordless Roman ShadeInstallation InstructionsStep 1 – ChecklistYou will need the following tools:- Drill- Pencil- Step Ladder- Tape Measure- Small Level- Light Weight Hammer- ScrewdriverStep 5 – Maintaining Your ShadeDust your shades with a soft clean cloth or a feather duster. Lower theshade to its fullest length for a complete cleaning. You can also detachthe shade from the bar, with the hook and loop fastener and lightlyshake for a simple cleaning.*Top fabric face is detachable, but not fully removable.Mounting inside the Window Frame (Ceiling)Step 2 – Mounting BracketsThe Roman Shade (a) can be mounted two ways; either Inside (CeilingMount) or Outside (Wall Mount) of your window frame using the providedBrackets (b). You will need to leave 3-5 inches of space from the ends ofthe Headrail (e) to properly mount the Brackets. ALWAYS use the WallAnchors (d) if you are mounting the brackets onto dry wall.Using a 13/64 drill bit, drill a hole for the bracket screws.With a light weight hammer, insert the anchors until flush with the surface.Mounting Outside the Window Frame (Wall)Fix the Brackets (b) on the wall outside and above the window frame.Ensure that the Brackets are moved in 3-5 inches from the sides of thewindow frame. Then place the Bracket Screws (c) through holes on theback plate of the Bracket and tighten until securely fastened to the wall.Follow the same instructions as above to install the wall anchor,then place the bracket over the anchor insert the screw and fastenStep 4 – Operation of Your ShadeTo lower the shade:Pull the handle, on the back, to lower down the shade until the desiredheight. Pull the handle again to hold the shade in place.To raise the shade:Pull the handle, on the back, twice to release the shade. Lift to thedesired height then pull the handle again to hold the shade in place.Headrail (e)(a)(b)Step 3 – Fitting the Shade & Securing the HeadrailPlace the Headrail (e) onto theBrackets (b) by inserting theback side of the Headrail (d) on firstand then pushing the front sideupward until it snaps into place.There should be an audible click,when the Headrail is secured.Once secured, reattach the Roman Shade (a) to the hook and loopfastener on the front of the Headrail (e).For easier fitting, detach theRoman Shade (a) from the hookand loop fastener on the frontof the Headrail (e).*Top fabric face is detachable,but not fully removable.Content27in. x 64in.31in. x 64in.33in. x 64in.35in. x 64in.ShadeSizeShade(a)Bracket(b)BracketScrew(c)WallAnchor(d)111122224444444439in. x 64in. 1 2 4 4 |
Related manuals for Eclipse 22716EDR3
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine