Installation InstructionsGU10 Drive/Walk Over LightPRODUCT CODE: 3732 / 3732 SQPlease read instructions carefully.This product should only be installed by a qualified electricianPlease retain these instructions for future reference.SPECIFICATIONS• Cast aluminium outdoor fitting, toughened glass lamp cover, mounting bracket and spike.• Supply: 240V/AC, 50Hz• Lamp type: GU/GZ10 240V Max 50W or CFL-GU10• Protection against electric shock: Class 1 - therefore must be earthed.• Supply Cable (complete with 2m cable and connection box, supplied): use 3 x 1mm2conductors.• Temperature Range: -20° • Ingress Protection: IP67TO BEGIN INSTALLATION• Ensure mains supply is switched off.• For safety, and in order to avoid unexpected damage to the product, please install a safetydevice when installing this product, for example, a two-pole fused 6Amp switch, etc.• Make connection to the electrical supply in accordance with the following code: the terminalconnector is located in the square connection box, supplied (attached to cable).LIVE – Brown or Red.NEUTRAL – Blue or Black.EARTH – Green and Yellow.• Ensure that a minimum distance of at least 300mm between the light and any flammablesurface.• Do not operate the fitting without the glass safety shield, or cracked or broken glass safetyshield. If cracked or broken, the glass safety shield should be replaced before further use.INSTALLATIONTo mount in ground1. Choose suitable location, and make a hole 82mm in diameter, and a minimum of 170mmdeep.2. To flush mount the fitting with the surface, open the top 10mm of the hole to a diameter of108mm.3. With the glass cover, stainless steel surround and aluminium fixture removed, install plasticsleeve securely in ground, secure aluminium fixture onto sleeve. Fit glass with seal, andstainless steel surround.QualityAssuranceyearsons carefully before installation.lified electrician must install this light fitting.:nium outdoor fitting, toughened glass lamp cover, and stainless steel trim.0V/AC, 50HzGU/GZ10 240V Max 50W or CFL-GU10.against electric shock: Class 1 - therefore must be earthed.le (complete with 2m cable and connection box, supplied): use 3 x 1mm2.re Range: -20° < to < +40°C.tection: IP67TALLATION:ins supply is switched off.and in order to avoid unexpected damage to the product, please install ace when installing this product, for example, a two-pole fused 6Amp switch,3732GU/GZ10240V, 50WCFL-GU10 7W 240VIIPP6677
