Eclipse Security ECL-ACC997 Manual
ECL-ACC997 / ECL-ACC999 V121203ECL-ACC999ECL-ACC997orP1P2P3P6P4P7P5123P1 P2 P3P4 P5 P6 P7※12345Contents1 ProductProtection PlugSecurity Torx WrenchesSecurity Torx: M3x10Flat Head Cap PhilipsTapping Screw: 4x20Wire Application Wire Color DescriptionLock Relay 1 Blue White (N.O.)DC24V1Amp2 Purple White (N.C.)DC24V1AmpCommon-COM-Point 3 White (COM)DC24V1AmpDoor Contact 4 Orange Negative Trigger InputExit Switch 5 Purple Negative Trigger InputAlarm Relay 6 Gray Transistor Output Max. 12V/100mA(Open Collector Active Low)Power 7 Thick Red DC 12V8 Thick Black DC 0VP1Cable:Wire Application Wire Color DescriptionAnti-TamperSwitch1 Red N.C.2 Orange COM3 Yellow N.O.P5Cable:Wire Application Wire Color DescriptionPower 1 Red DC 12V OutputSecurity trigger signal 2 Purple Security trigger signal OutputArming 3 Red White Arming OutputDuress 4 Yellow White Duress OutputP6Cable:Wire Application Wire Color Description1 --- ---2 --- ---TCP/IP Output3 Orange White Net - TX+4 Orange Net - TX-5 Green White Net - RX+6 Gerrn Net - RX-7 --- ---P3Cable:Wire Application Wire Color DescriptionRS-485 for LiftController1 Thick Green RS-485(B-)2 Thick Blue RS-485(A+)P4Cable:Wire Application Wire Color DescriptionBeeper 1 Pink Beeper Output 5V/100mA, LowLED 2 Yellow Red LED Output 5V/20mA, Max3 Brown Green LED Output 5V/20mA, MaxDoor Output 4 Blue White Transistor Output Max. 12V/100mA(Open Collector Active Low)Wiegand 5 Thin Green Wiegand DAT: 0 Input6 Thin Blue Wiegand DAT: 1 InputWG Door Contact 7 Orange Negative Trigger InputWG Exit Switch 8 Purple Negative Trigger InputP2Cable:External WG keyboard※ If you want to program system on controller directly, please order WG keyboard then install it according to the following pattern.Remove the Protection plug that in the bottom left.(※ Do not lose protection plug or it will affect the protection level.)WG Keyboard cable will be connected to the pin board.WG Keyboard connected to the controller from the bottom left of the hole.When you finish programming system, please put protection plug backto the controller.InstallationConnector TableWire Application Wire Color DescriptionDoorbell 1 Black White Transistor Output Max. 12V/100mA(Open Collector Active Low)2 Black GNDP7Cable: (For the controller that doorbell function.)Pull the cables from the square hole of the mounting plate.Use a screwdriver to screw the base onto the wall.Connect the terminal cables to the body and attach the body to the mounting plate.Assemble the covers with the Allen key and screws (accessories supplied).Turn on the power and LED will light and beep will sound.※ only provide to the controller that have doorbell function.P73 User Guide2 Optional 4 Terminal Cables 5 ToolsDigital RelayWGkeyboard |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine