Faber SP4 Installation And Operating Instructions Manual

Also see for silver feeling sp4: User manual

Contents

Faber SP4 Installation And Operating Instructions Manual Manual pdf 1 page image

THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE.Dimensions(millimetres)Installation and Operating InstructionsElectrical08/18936/0 Issue 0Fig. 1Important Safety Advice:When using electrical appliances, basicprecautions should be followed to reduce the riskof fire, electric shock, and injury to persons,including the following :• If the appliance is damaged, checkimmediately with the supplier beforeinstallation and operation.• Do not use this heater in the immediatesurroundings of a bath, shower or swimmingpool.• Do not use outdoors.• This heater must not be located immediatelyabove or below a fixed socket outlet orconnection box.• Do not cover - Overheating will result if theheater is accidentally covered.• In the event of a fault unplug the heater.• Unplug the heater when not required for longperiods.• Although this heater complies with safetystandards, we do not recommend its use ondeep pile carpets or on long hair type of rugs.• Do not leave young children, the elderly, orthe infirm unsupervised in the vicinity of theheater.• The appliance must be positioned so that theplug is accessible.• If the supply cord is damaged it must bereplaced by the manufacturer or service agentor similarly qualified person in order to avoida hazard.WARNING – THIS APPLIANCE MUST BE EARTHEDThis heater must be used on an AC ~ supply only and thevoltage marked on the heater must correspond to the supplyvoltage.Do not switch the appliance on until properly installed. Pleaseread all the safety warnings and operating instructions.Unpack the heater carefully and retain the packaging for pos-sible future use, in the event of moving or returning the fire toyour supplier.Contents of Carton.• SP4 Heater.• Wall fixing bracket.• Six fixing screws and six wall plugs.• Remote control and batteries ( 3 AAA’s type).• Spare bulb.Do not connect the heater to an electricity supply until it isinstalled on a wall correctly. - see ‘Installation’.When in operation there is a 300 watt heat output from thefuel effect, and an additional 120 watt output when the heatedglass panel is in operation.The heater can be used remotely or manually. - see ‘Opera-tion’.General features of remote control are:• Activate/Deactivate heated glass panel.• The illumination of fuel effect can be increased ordecreased.• Programmable timer.Please note: Used in an environment where background noiseis very low, it may be possible to hear the motor which oper-ates the flame effect. This is normal and should not be a causefor concern.GeneralWall Fire SP4Model No: SP4