WFR50 AC WIFI ReceiverSPECIFICATION and INSTRUCTION SHEETELECTRICAL SPECS: 120 Volts, 60 Hertz, Fan 1.0 ampFAN MODEL USED: May be used in conjunction with TR500 Remote Control.Compatible with most Fanimation AC motor fans - see catalog or visit our website,www.FANIMATION.com for more informationNOTE: If fan or supply wires are different colors than indicated, have this unit installed by a qualified electrician.WARNINGTo avoid possible electrical shock, be sure electricity isyou are not sure if the outlet box is grounded, contact alicensed electrician for advise, as it must be grounded forsafe operation.INSTALLATION INSTRUCTIONS:6. Ceiling fan must be set at HIGH speed and light kit (If any)at the ON position by pressing the “Light Switch” afterinstallation.3. Install Receiver in the Hanger Bracket:2. The breaker and wall switch that controls the power to thefan must be in the off position. Please make sure that thewall switch that controls the power to the fan and ligth kitif installed, is a true on off toggle or rocker switch. It cannothave a dimming function on of any kind.–BLACK Receiver Unit wire (AC IN L) to BLACK supply wire.–WHITE Receiver Unit wire (AC IN N) to WHITE supply wire.–WHITE Receiver Unit wire (TO MOTOR N) to WHITE fanwire.–BLACK Receiver Unit wire (TO MOTOR L) to BLACK fanwire.–BLUE Receiver Unit wire (FOR LIGHT DOWN) to BLUE lightwire.installation of ceiling canopy.4. The receiver has a wifi antenna that can be used if youexperience range issues. (Figure 4)5. Restore electrical power at the breaker and wall switch.7. Follow the app set up instructions on the following pages.WHITE(AC IN N)BLACK(AC IN L)BLACK(TO MOTOR L)WHITE(TO MOTOR N)AC POWER SUPPLYBLACK(ANTENNA)WHITE(WIFI ANTENNA)BLUE(FOR LIGHTDOWN)Figure 3Figure 4 (Optional)Figure 1WIFI antennaCeilingAfter Installation WIFI Antennamount to ceiling usingwood screw1. Dip Switch Set UpNOTE: The remote unit has 32 different codecombinations. To prevent possible interference from orto other remote units, simply change the combinationcode in the remote and receiver.NOTE: Factory setting is all up. Do not use this position.WARNING: To avoid possible fire or shock, make sure that theelectrical wires are completely inside the outlet box and notpinched between the wall plate and the wall.WARNING: Check to see that all connections are tight, includingground, and that no bare wire is visible at the wire connectors,except for the ground wire. Do not operate fan unless blades arein place. Noise and fan damage could result.• To set the code on receiver unit, slide dip switchesto the same positions as set on the remote, if using inconjunction with the TR500 remote (Figure 1)ANTENNA(Leave connectedand do not cut)WIFI AntennaHanger BracketFigure 2Dip Switch1