OUTDOOR COMMERCIAL WALL LIGHTINSTALLATION INSTRUCTIONSMODEL S15CWPK/850/BZFEIT ELECTRIC COMPANY | PICO RIVERA, CA | (800) 543-3348 | FAX (562) 908-6360 | www.feit.comWARNING: These products may represent a possible shock or fire hazard if improperly installed or attached in any way.Products should be installed in accordance with the owners manual, current electrical codes and/or the current NationalElectric Code (NEC).CAUTION, IMPORTANT SAFETY INSTRUCTIONS - Make sure the supply voltage is thesame as the rated luminaire voltage. Do not install where marked operating temperaturesexceed the ignition temperature of the hazardous atmosphere. Do not operate in ambienttemperatures above those indicated on the luminaire nameplate. To avoid the risk of fire,explosion, or electric shock, this product should be installed, inspected and maintained by aqualified electrician only, in accordance with all applicable electrical codes. Be certainelectrical power is OFF before and during installation and maintenance.Note: Save these instructions for future reference.For supply connections use wire rated for at least 90°CCAUTION: Input 120-277VACPARTS INCLUDED(1) Outdoor commercial wall light(3) Mounting screws(3) Plastic anchors(3) Wire nutsLIMITED WARRANTYThis product is warranted to be free fromdefects in workmanship and materials for upto 5 years from date of purchase. If it fails todo so, please contact Feit Electric atinfo@feit.com or call 1-866 326-BULB (2852)for instructions on replacement. Do notreturn the product to the store.For comments please write to:Feit ElectricCustomer Service Department4901 Gregg Road, Pico Rivera, CA 90660This device complies with part 15 of the FCC Rules. Operation is subject tothe following two conditions: (1) This device may not cause harmfulinterference, and (2) this device must accept any interference received,including interference that may cause undesired operation. Note: Thisequipment has been tested and found to comply with the limits for a Class Bdigital device, pursuant to part 15 of the FCC Rules. These limits aredesigned to provide reasonable protection against harmful interference in aresidential installation. This equipment generates, uses and can radiate radiofrequency energy and, if not installed and used in accordance with theinstructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particularinstallation. If this equipment does cause harmful interference to radio ortelevision reception, which can be determined by turning the equipment offand on, the user is encouraged to try to correct the interference by one or moreof the following measures: Reorient or relocate the receiving antenna. Increasethe separation between the equipment and receiver. Connect the equipmentinto an outlet on a circuit different from that to which the receiver is connected.Consult the dealer or an experienced radio/TV technician for help.14.3 in.9.3 in.7.6 in.