GE DNCD450EG1WC Installation Manual

Also see for DNCD450EG1WC: Owner's manual

GE DNCD450EG1WC Installation Manual Manual pdf 1 page image

InstallationInstructions ElectricDryer54Questions on Installation? Call: 1-800-GECARES (US)or Visit our Web site at: www.GEAppliances.com (US)BEFOREYOU BEGINRead these instructions completely and carefully.•IMPORTANT - Savetbeseinstructions for local inspector's use.•IMPORTANT - Observeallgoverning codes and ordinances.• Note to Installer - Be sure to leave these instructions withthe customer.• Note to Customer - Keep these instructions with your Useand Care Book for future reference.• This dryer must be exhausted to the outdoors.• Before tile old dryer is removed from service or discarded,remove tile dryer door.• Service information and the wiring diagram are located inthe control console.• Do not allow children on or in tile appliance. Closesupervision of children is necessary when tile appliance isused near children.FOR YOUR SAFETY:WARNING• Use only rigid metal or flexible metal 4-in. diameterductwork for exhausting to the outdoors. Neveruse plastic or other combustible, easy-to-puncture ductwork.• This appliance must be properly grounded and installedas described in these instructions.• Do not install or store appliance in an area where itwill be exposed to water and/or weather• Install the dryer where the temperature is above 50°Ffor satisfactory operation of the dryer control system.NOTE: Installation and service of this dryerrequires basic mechanical and electrical skills.It is your responsibility to contact a qualifiedinstaller to make the electrical connections,ITOOLS YOUWILL NEEDSLIPJOINTPLIERS[_FLATBLADESCREWDRIVERPHILLIPSSCREWDRIVER%MATERIALS YOU WILL NEED4"DIA.METALDUCT 4"(RECOMMENDED) DUCTCLAMPS(2)OR4"SPRINGCLAMPS(2)4"DIA.FLEXIBLEMETALDUCT(IFNEEDED)%4"DIA.METALELBOWDUCTTAPEEXHAUSTHOOD SAFETYGLASSES_x_ 3/4"_RELIEFGLOVES ULRECOGNIZEDUDRYERPOWERCORDKIT(NOTPROVIDEDWITHDRYER)ULRATED120/240V,30AWITH3 OR4PRONGS.IDENTIFYTHEPLUGTYPEASPERTHEHOUSERECEPTACLEBEFOREPURCHASINGLINECORD.Step 1Step 2Step 3Step 4Step 5Step 6Step 7Prepare the Area and Exhaust for Installation ofNew Dryer (see section 1).Check and Ensure the Existing External Exhaust isClean (see section 1) and Meets Attached InstallationSpecifications (see section 3).Remove the Foam Shipping Pads (see section 1).Move the Dryer to the Desired Location.Connect the Power Supply (see section 2).Connect the External Exhaust (see section 4).Level Your Dryer (see section 5).Step 8Step 9Check the Operation of the Power Supplyand Venting,Place the Owners Manual and the InstallationInstructions in a Location Where They Will BeNoticed By the Owner.For Alcove or Closet Installation, see section 6.For Bathroom or Bedroom Installation, see section 7.For Mobile or Manufactured Home see, section 8.For side or bottom exhaust, see section 9.