GE JB700DN Dimensions And Installation Information

Also see for JB700DN: Owner's manual Installation instructions Dimensions and installation information

GE JB700DN Dimensions And Installation Information Manual pdf 1 page image

Dimensions and Installation Information (in inches)For answers to your Monogram,® GE Profile™ orGE® appliance questions, visit our website atge.com or call GE Answer Center® service,800.626.2000.JB700DNGE® 30" Free-Standing Electric RangeListed byUnderwritersLaboratoriesAll GE ranges are equipped withan Anti-Tip device. The installationof this device is an important,required step in the installationof the range.Specification Revised 10/08 321515KW Rating240V 12.0208V 9.0Breaker Size40 Amps †302529-7/846-7/82-1/27-1/225-3/847-5/82-1/2Acceptable electricaloutlet area30_install_fse_ge.epsDimension from wall to front ofclosed oven door handle is 27-3/4302529-7/846-7/82-1/27-1/225-3/847-5/82-1/2Acceptable electricaloutlet area30_install_fse_ge.epsDimension from wall to front ofclosed oven door handle is 27-3/4.†Note: Check local codes for required breaker size.Effective January 1, 1996, the National ElectricalCode requires that new construction (not existing)utilize a 4-conductor connection to an electric range.Receptacle Locations: Locally approved flexibleservice cord or conduit must be used becauseterminals are not accessible after range installation.See shaded area in drawing for location of electricaloutlet box. Recommended outlet locations allowrange to be installed directly against wall.Note: 30" ranges conform to U.L. requirements for0" spacing from adjacent walls below countertops.To reduce possibility of scorching walls, engineeringrecommends a minimum of 1-1/2" spacing to allowfor possible extended, high-heat, no-load heatingelement operation.Installation information: Before installing, consultinstallation instructions packed with product forcurrent dimensional data.All 30" GE gas and electric range backguardsare 30-7/8" wide.*Note: 30" ranges conform to U.L. requirementsfor 0" spacing from adjacent walls belowcountertops. To reduce possible scorching ofwalls, engineering recommends a minimum of1-1/2" spacing to allow for possible extended,high heat, no-load heating element operation.*Except these models: JGBS07, JGBS04, JGBP90,all GE Profile free-standing electric and gasrangesFits most countertop backsplash applications.Consult Use & Care Manual for detailedinstallation instructions.30-7/8"

/ 2

Related manuals for GE JB700DN