†Note: Check local codes for required breaker size.Effective January 1, 1996, the National Electrical Code requiresthat new construction (not existing) utilize a 4-conductorconnection to an electric range.Receptacle Locations: Locally approved flexible service cordor conduit must be used because terminals are not accessibleafter range installation. See shaded area in drawing for locationof electrical outlet box. Recommended outlet locations allowrange to be installed directly against wall.Note: 30" ranges conform to U.L. requirements for 0" spacingfrom adjacent walls below countertops. To reduce possibilityof scorching walls, engineering recommends a minimum of1-1/2" spacing to allow for possible extended, high-heat,no-load heating element operation.Installation information: Before installing, consult installationinstructions packed with product for current dimensional data.Dimensions and Installation Information (in inches)For answers to your Monogram,® GE Profile™ orGE® appliance questions, visit our website atge.com or call GE Answer Center® service,800.626.2000.Listed byUnderwritersLaboratoriesAll GE ranges are equipped withan Anti-Tip device. The installationof this device is an important,required step in the installationof the range.Specification Created 4/08 321506KW Rating240V 10.5208V 7.9Breaker Size40 Amps †302529-7/846-7/82-1/27-1/225-3/847-5/82-1/2Acceptable electricaloutlet area30_install_fse_ge.epsDimension from wall to front ofclosed oven door handle is 27-3/4JBP62DMGE® 30" Free-Standing CleanDesign™ Electric Range