GE JGP328 Installation Instructions Manual

Also see for JGP328: Owner's manual Owner's manual Owner's manual Planning guide Owner's manual

Contents

GE JGP328 Installation Instructions Manual Manual pdf 1 page image

131-10613-3 (11-06 JR)BEFORE YOU BEGINRead these instructions completelyand carefully.• IMPORTANT — Save theseinstructions for local inspector’s use.• IMPORTANT — Observe allgoverning codes and ordinances.• Note to Installer – Be sure to leave theseinstructions with the Consumer.• Note to Consumer – Keep theseinstructions for future reference.• Product failure due to improper installationis not covered under the Warranty.WARNING — This appliance mustbe properly grounded.• IMPORTANT — Leak testing of theappliance shall be conducted according tothe manufacturer’s instructions.• Proper installation is the responsibilityof the installer and product failure due toimproper installation is NOT covered underwarranty.IN THE COMMONWEALTH OFMASSACHUSETTS:• This product must be installed by alicensed plumber or gas fitter.• When using ball-type gas shut-off valves,they shall be the T-handle type.• A flexible gas connector, when used, mustnot exceed 3 feet.Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: ge.comIn Canada, call 1.800.361.3400 or Visit our Website at: www.geappliances.caInstallation 30″ Sealed Gas CooktopInstructions JGP328, JGP330, JGP933,JGP940, JGP945FOR YOUR SAFETY:WARNING — If the informationin this manual is not followed exactly, a fire,explosion or gas leak may result causingproperty damage, personal injury or death.Do not store or use gasoline or otherflammable vapors and liquids in the vicinityof this or any other appliance!WHAT TO DO IF YOUSMELL GAS:• Do not try to light any appliance. Do nottouch any electrical switch; do not use anyphone in your building.• Immediately call your gas supplier from aneighbor’s phone. Follow the gas supplier’sinstructions.• If you cannot reach your gas supplier, callthe fire department.Installation and service must be performedby a qualified installer, service agency orthe gas supplier.This cooktop has been design certifiedby CSA International. You’ll find safetyprecautions in your Owner’s Manual.Read them carefully.• Installation of this cooktop must conformwith local codes or in the absence of localcodes with the National Fuel Gas Code,ANSI Z223.1/NFPA 54–Latest edition.• Be sure your cooktop is installed properlyby a qualified installer or service technician.• To eliminate reaching over surface burners,cabinet storage above burner should beavoided.• Do not install the unit near an outside dooror where a draft may affect its use.WARNING — Disconnect allelectrical power at the main circuit breakeror fuse box before installing.