InstallationInstructionsBEFORE YOU BEGINRead these instructions carefully and completely.• IMPORTANT — Save these instructionsfor local inspector’s use.• IMPORTANT — Observe all governingcodes and ordinances.• Note to Installer – Be sure to leave theseinstructions with the consumer.• Note to Consumer – Keep these instructions forfuture reference.• Proper installation is the responsibility of the installer• Product failure due to improper installation is notcovered under the Warranty.Range Hood Connection toWall SwitchJVX3240, JVX3300, JVX5305 and JVX5365TOOLS NEEDEDIf you have questions, call GE Appliances at 800.GE.CARES (800.432.2737).31-11120-1 09-17 GEA1/4” NutdriverFlat blade and PhillipsHead ScrewdriversFOR YOUR SAFETYWARNING Before beginning the installation,switch power off at service panel and lock theservice disconnecting means to prevent power frombeing switched on accidentally. When the servicedisconnecting means cannot be locked, securelyfasten a prominent warning device, such as a tag, tothe service panel.WARNING TO REDUCE THE RISKOF FIRE, ELECTRIC SHOCK ORINJURY TO PERSONS, OBSERVE THEFOLLOWING:A Installation work and electrical wiring must bedone by qualified person(s) in accordance withall applicable codes and standards, includingfire-rated construction.B When cutting or drilling into wall or ceiling, do notdamage electrical wiring and other hidden utilities.POWER SUPPLYIMPORTANT – (Please read carefully)WARNING FOR PERSONAL SAFETY, THISAPPLIANCE MUST BE PROPERLY GROUNDED.Remove house fuse or open circuit breaker beforebeginning installation.Do not use an extension cord or adapter plug withthis appliance. Follow National Electrical Codes orprevailing local codes and ordinances.Electrical supplyThese vent hoods must be supplied with 120V, 60Hz,and connected to an individual, properly groundedbranch circuit, and protected by a 15 or 20 amp circuitbreaker or time delay fuse.• Wiring must be 2 wire with ground.• If the electrical supply does not meet the aboverequirements, call a licensed electrician beforeproceeding.• Route house wiring as close to the installationlocation as possible in the ceiling or wall.• Connect the wiring to the house wiring inaccordance with local codes.Grounding instructionsThe grounding conductor must be connected toa ground metal, permanent wiring system, or anequipment-grounding terminal or lead on the hood.WARNING The improper connection of theequipment-grounding conductor can result in a riskof electric shock. Check with a qualified electricianor service representative if you are in doubt whetherthe appliance is properly grounded.Wire cutter/stripper