GE JX2027 Installation Instructions Manual

Also see for JX2027: Installation instructions Installation instructions

GE JX2027 Installation Instructions Manual Manual pdf 1 page image

PART QUANTITY❒ Trim Frame 1❒ Bottom Duct 1❒ Side Duct 1❒ 4 mm x 12 mm 23Round-Head Screws (21 requiredfor installation)❒ 4 mm x 14 mm 6Flat-Head Screws (4 required forinstallation)❒ Anti-Tip Brace 1❒ Anti-Tip Bracket 1❒ Upper Duct 1❒ Top Bracket 1❒ Bottom Bracket 1❒ Templates 2PARTS INCLUDEDQuestions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: ge.comREAD CAREFULLY.KEEP THESE INSTRUCTIONS.Installation Built-In Trim KitsInstructions JX2027 and JX2030Read these instructions completely and carefully.• IMPORTANT – Save these instructions for localinspector’s use.• IMPORTANT – Observe all governing codes andordinances.• Note to Installer – Be sure to leave these instructions with theConsumer.• Note to Consumer – Keep these instructions for future reference.• For easier installation and personal safety, we recommend that two peopleinstall this microwave oven.WARNING — This oven must be plugged into a properlygrounded 3-hole, 120V receptacle as required by the National Electrical Code.❒ BEFORE YOU BEGIN • Do not alter or modify any part of this kit or the oven.• Unplug the microwave oven before attempting installation of this kit.• Skill level – Installation of this appliance requires basic mechanical andelectrical skills.• Completion time – 1-3 hours• Proper installation is the responsibility of the installer.• Product failure due to improper installation is not covered under the Warranty.• This kit is UL listed for installation alone or over any GE/GE Profilesingle electric wall oven. Not for use adjacent to (within 2 feet of) any gasor electric range, cooktop or oven.• This kit is for use on models: PEB2060DMBB, PEB2060DMWW,PEB2060DMCC, PEB2060SMSS, JEB1860DMBB, JEB1860DMWW,JEB1860DMCC and JEB1860SMSS.TOOLS YOU WILL NEED❒ Phillips screwdriver❒ Pencil❒ Tape measure❒ Awl or punch❒ Drill with 7⁄64″ bit or #35FOR YOUR SAFETY:WARNING – Before beginning theinstallation, switch power off at service panel and lockthe service disconnecting means to prevent powerfrom being switched on accidentally. When the servicedisconnecting means cannot be locked, securely fastena prominent warning device, such as a tag, to theservice panel.❒ Level❒ Scissors (optional)1NOTE: This kit has extra screws to prevent the technician from spending extratime locating a replacement screw in case they lose one during installation.

/ 4

Related manuals for GE JX2027