For answers to your Monogram,® GE Profile™ orGE® appliance questions, visit our website atge.com or call GE Answer Center® service,800.626.2000.170133Specification Created 10/08ZGG300NBPSS - Natural Gas Built-in Outdoor GrillZGG300LBPSS - LP Gas Built-in Outdoor GrillDimensions and Installation Information (in inches)Outdoor Built-in CooktopThese grills are designed to be installed into a non-combustible enclousure.• The grill drops into the opening and hangs fromthe side flanges. It does not require support fromthe bottom.• The cutout must be completely covered withnon-combustible material such as stone, brick,ceramic tile, concrete board, etc. The countertopsurface and edges must be flat and level.• If the countertop has an overhang, it must benotched or cut back flush with the front face ofthe cabinet below.• Allow at least 12" minimum clearance at theback of the grill when the exhaust is directed to awindow or surface that is difficult to clean. Allowat least 4" clearance behind the grill to allow thehood lid to open. See notched detail below.• Allow 12" minimum clearance on both sidesand the back of the grill to adjacent verticalcombustible construction.• These gas grills cannot be used below any type ofoverhead construction.• These grills are designed for outdoor use only. Donot locate the cooktop in a building, garage orother enclosed or semi-enclosed area.• Locate the backside of the grill away fromprevailing winds and avoid cooking in windyconditions.29-7/8"12" Min. to Combustibles4" Min. Clearance for Lidto Non-Combustibles27"26"*The weight of the grill is fully supported bythe side trims. The back of the grill overlapsthe back edge of the cutout.10-1/4" fromBottom ofSupport Flange*25-1/2"Countertop Depth27" to Frontof Control Panel28-1/2" to Front of Bullnose28-3/4"36"Min. 1-1/8" Min.10-7/8"24-1/2"Grill CutoutGas andElectricalLocationsOpeningfor OptionalAccess Doors