GE Profile JS998BK Dimensions And Installation Information

For answers to your Monogram,® GE Profile™ orGE® appliance questions, visit our website atge.com or call GE Answer Center® service,800.626.2000.Specification Revised 1/08 220452All GE ranges are equipped withan Anti-Tip device. The installationof this device is an important,required step in the installationof the range.Listed byUnderwritersLaboratoriesDimensions and Installation Information (in inches)28-1/4*36Maintainat least 6"from nearestcombustiblesurface.AcceptableElectricalOutlet Area30" Slide-In RangeDimensions (in inches)45-1/82-1/4564-1/23030" Min.15" Min. 630" Slide-in Elec. RangeAug. 8, 2003 -km23-3/163030If you are NOT using theFiller strip or Backguard:If you are using theFiller strip or Backguard:25*Wall to front ofclosed door handleon model JSP34.28" on modelsJSP26/JSS26/16.Note: Range may be placed with 0" clearance (flush) at the back wall and side wallsbelow countertop if the range side trims above the countertop extend beyond the cabinetfronts at least 1/4". (Self-clean models only.) Maintain at least 6" distance from nearestcombustible surface.3031-1/228-1/4*36Maintainat least 6"from nearestcombustiblesurface.AcceptableElectricalOutlet Area30" Slide-In RangeDimensions (in inches)45-1/82-1/4564-1/23030" Min.15" Min. 630" Slide-in Elec. RangeAug. 8, 2003 -km23-3/163030If you are NOT using theFiller strip or Backguard:If you are using theFiller strip or Backguard:25*Wall to front ofclosed door handleon model JSP34.28" on modelsJSP26/JSS26/16.Note: Range may be placed with 0" clearance (flush) at the back wall and side wallsbelow countertop if the range side trims above the countertop extend beyond the cabinetfronts at least 1/4". (Self-clean models only.) Maintain at least 6" distance from nearestcombustible surface.3031-1/2Note: Cabinets installed adjacent to slide-in ranges must have an adhesionspec of at least 194° temperature rating.Note: 30" ranges conform to U.L. requirements for 0" spacing from adjacentwalls below countertops. To reduce possibility of scorching walls, engineeringrecommends a minimum of 1-1/2" spacing to allow for possible extended,high-heat, no-load heating element operation.Receptacle Locations: For all 30" Slide-In Ranges locally approved flexibleservice cord or conduit must be used because terminals are not accessibleafter range installation. See shaded area in drawing for location of electricaloutlet box. Recommended outlet locations allow range to be installed directly against rear wall.KW Rating240V 12.8208V 8.7Breaker Size240V 40 Amps208V 40 AmpsInstallation information: Before installing, consult installation instructionspacked with product for current dimensional data.JS998TK/BKGE Profile™ 30" Slide-In Electric Range with Trivection™ TechnologyOptional Kits For Slide-InElectric Ranges(Available At Additional Cost)Accessory Backguards(Attaches to the back of rangeas a backguard when unit isinstalled in 30" free-standingcutout)JXS32SS (Stainless) - 4" HighJXS32WW (White) - 4" HighJXS32CC (Bisque) - 4" HighJXS32BB (Black) - 4" HighJXS37WW (White) - 5-1/4" HighJXS37CC (Bisque) - 5-1/4" HighJXS37BB (Black) - 5-1/4" HighBody Sides(Slide-in ranges are soldwithout sides installed. Canbe installed on either leftor right when unit has oneexposed side [no cabinetadjacent]. Kit contains1 body side)JXS77WW (White)JXS77CC (Bisque)JXS77BB (Black)Vertical Side Trim Kits(If cabinet cutout width ismore than 30", a verticalside trim kit may be used toclose the gap between therange and cabinet)JXS86WW (White)JXS86CC (Bisque)JXS86BB (Black)Optional Lower Trim Kits(If counter height is greaterthan 36.5", a lower trim kitis recommended to extendthe useful height to 38"maximum)JXS56WW – WhiteJXS56CC – BisqueJXS56BB – BlackOptional Top Filler KitsJXS66WW – WhiteJXS66CC – BisqueJXS66BB – BlackAcceptableElectricalOutlet Area30" Min.30" Min.Shave Raised Edge To Clear31-1/8" Wide Control PanelExcluding Models JSS28 and JSP392-7/8"To FrontSurface OfCountertop20-5/8" DoorClearanceFrom FrontSurface ofCountertop31-1/43025-3/4**Recommended6" Min.From Walls23-3/1615" Min.A/B*13" Max.2-1/230259/167-1/22-1/2AccessoryBackguard2436-1/4*JXS37 is 5-1/4" an(excluding handle) **Total depth from wfront of closed oveincluding handle i35-7/8"–38"from floor tocountertopAcceptableElectricalOutlet Area30" Min.30" Min.Shave Raised Edge To Clear31-1/8" Wide Control PanelExcluding Models JSS28 and JSP392-7/8"To FrontSurface OfCountertop20-5/8" DoorClearanceFrom FrontSurface ofCountertop31-1/43025-3/4**Recommended6" Min.From Walls23-3/1615" Min.A/B*13" Max.2-1/230259/167-1/22-1/2AccessoryBackguard2436-1/4*JXS37 is 5-1/4" and JX(excluding handle) **Total depth from wall tfront of closed oven doincluding handle is 2735-7/8"–38"from floor tocountertop

/ 2

Related manuals for GE GE Profile JS998BK