Dimensions and Installation Information (in inches)For answers to your Monogram,® GE Profile™ orGE® appliance questions, visit our website atge.com or call GE Answer Center® service,800.626.2000.Listed byUnderwritersLaboratoriesAll GE ranges are equipped withan Anti-Tip device. The installationof this device is an important,required step in the installationof the range.†Note: Check local codes for required breaker size.Effective January 1, 1996, the National Electrical Code requires that newconstruction (not existing) utilize a 4-conductor connection to an electric range.Receptacle LocationsLocally approved flexible service cord or conduit must be used because terminalsare not accessible after range installation. See shaded area in drawing for locationof electrical outlet box. Recommended outlet locations allow range to be installeddirectly against wall.Note: 30" ranges conform to U.L. requirements for 0" spacing from adjacentwalls below countertops. To reduce possibility of scorching walls, engineeringrecommends a minimum of 1-1/2" spacing to allow for possible extended, high-heat, no-load heating element operation.Installation Information: Before installing, consult installation instructionspacked with product for current dimensional data.KW Rating240V 13.9208V 10.4Breaker Size40 Amps†PB970SPGE Profile™ 30" Free-Standing Electric RangeSpecification Revised 5/09 221023302437-1/229-7/825-3/4*45473Acceptable electricaloutlet areaOrient the electricalreceptacle so the lengthis parallel to the floor.*Dimension from wall to front ofclosed oven door handle is 28-7/8.fse_dual_cavity_install.eps