GE Profile PEB9159SJSS Dimensions And Installation Information

Also see for PEB9159SJSS: Owner's manual

Listed byUnderwritersLaboratoriesPEB9159SJSSGE Profile™ Series 1.5 Cu. Ft. Countertop Convection/Microwave OvenDIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)For answers to your Monogram, GE Café™ Series, GE Profile™ Series orGE Appliances product questions, visit our website at geappliances.comor call GE Answer Center® Service, 800.626.2000. Specification Revised 3/16OPTIONAL ACCESSORY TRIM KITS FOR GE MICROWAVEOVENS (AVAILABLE AT ADDITIONAL COST)For a custom built-in appearance, these kits allow built-in installationof the countertop microwave oven into a wall or cabinet alone and areU.L. approved for installation over a GE single electric wall oven.These kits should not be installed over a gas wall oven.NOTE: 120V, 60-cycle, grounded power receptacle location optionalon back within cabinet opening.INSTALLATION INFORMATION: This information is not intendedto be used for installing unit described. Before installing, consultinstallation instructions packed with product/kit for currentdimensional data.ACCESSORYTRIM KITS "Z"MAXHEIGHTTRIMKITS30" Deluxe 29-3/4" 19-1/8" JX9153SJ27" Deluxe 26-7/8" 19-1/8" JX9152SJEXTERIOR DIMENSIONS (IN INCHES)Height 12-3/16"Width 21-3/16"Depth 16"Depth including bumpout 20"Depth from back of case to front legs 13"CABINET OVERLAP REQUIREMENTS 30" 27"A - Overlap of trim kit over top of cabinet 1" 1"B - Overlap of trim kit over bottom of cabinet 1" 1"C - Overlap of trim kit over sides of cabinet 3-5/16" 1-7/8"NOTE:Allow an additional inchof clearance beyond trimframe on all sides.ACCESSORY TRIM KIT ZJX9153 29-3/4"JX9152 26-7/8"19-1/8"Allow 3"clearance*For ADA compliance, the microwavemust be installed no higher than 37".AC23-1/8" ± 1/16"BracketTrimKit17-1/16" ± 1/16"36" MIN.*BZ18" MIN. receptaclein cabinet 16" MIN.receptacle outsidecabinetHeightPRODUCT DIMENSIONSWidthDepthDepth including bumpoutDepth from back of case to front legs12-3/16"21-3/16"16"20"13"12-3/16"21-3/16" 16"13"20"HeightPRODUCT DIMENSIONSWidthDepthDepth including bumpoutDepth from back of case to front legs12-3/16"21-3/16"16"20"13"12-3/16"21-3/16" 16"13"20"CABINET OVERLAP REQUIREMENTS 30" 27"A - Overlap of trim kit over top of cabinet 1" 1"B - Overlap of trim kit over bottom of cabinet 1" 1"C - Overlap of trim kit over sides of cabinet 3-5/16" 1-7/8"NOTE: Allow an additionalinch of clearance beyondtrim frame on all sides.

/ 2

Related manuals for GE PEB9159SJSS