GE Spacemaker DSKS333ECWW Dimensions And Installation Information

Also see for Spacemaker DSKS333EC: Owner's manual and installation instructions Installation instructions Dimensions and installation information Dimensions and installation information Dimensions and installation information

GE Spacemaker DSKS333ECWW Dimensions And Installation Information Manual pdf 1 page image

For answers to your Monogram,® GE Profile™ orGE® appliance questions, visit our website atge.com or call GE Answer Center® service,800.626.2000.360428Specification Revised 9/07Listed byUnderwritersLaboratoriesWSLP1100A/DSKS333ECGE Spacemaker ® Portable Washer and Stationary Dryer with Stack Rack DSR24RWDimensions and Installation Information (in inches)Washer Note: Washer wall outlet must be located within 36" of service cord entry.Wall outlet must not be located behind dryer.Dryer Note: Dryer wall outlet must be located within 36" of service cord entry andaccessible when dryer is mounted in position.WSLP1100HPortableWasherorWSLS1100HStationaryWasherDSKS433EB andDSKS333ECDryerStack RackDSDR24D22-7/81-5/85-1/22079-1/438"WSLP1100HPortableor37-1/2"WSLS1100HStationary24-1/2 25-1/231-1/2TopVent5-1/277-3/4stack rack DSR24 w/D33-1/446Special Installation RequirementsAlcove or Closet Installation:• If your dryer is approved for installation in an alcove or closet, it will be stated ona label on the dryer back.• The dryer MUST be exhausted to the outside.• Minimum clearances between dryer cabinet and adjacent walls or othersurfaces are:0" either side3" front and rear• Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52”.• Closet doors must be louvered or otherwise ventilated and must contain aminimum of 60 sq. in. of open area equally distributed. If this closet containsboth a washer and a dryer, doors must contain a minimum of 120 sq. in. of openarea equally distributed.• No other fuel-burning appliance shall be installed in the same closet witha gas dryer.Bathroom or Bedroom Installation:• The dryer MUST be exhausted to the outdoors.• The installation must conform with the local codes, or in the absence of localcodes, with the National Fuel Gas Code, ANSI Z223.Minimum Clearances other than Alcove or Closet Installation:• Minimum clearances to combustible surfaces0" both sides3" rear

/ 3

Related manuals for GE Spacemaker DSKS333EC