GE ZPBS360 Installation Instructions Manual

Also see for ZPBS360: Installation instructions

GE ZPBS360 Installation Instructions Manual Manual pdf 1 page image

BEFORE YOU BEGINRead these instructions completely and carefully.• Note to Installer – Be sure to leave theseinstructions with the Consumer.• Note to Consumer – Keep these instructions withyour Owner’s Manual for future reference.InstallationInstructionsACCESSORY PANEL KITSZPSS360 – Stainless SteelZPBS360 – Black AcrylicKit Contents• 2 Filler panels(with ZPSS360 only)• Door panel• Grille panelTools Required• Phillips screwdriver• Safety glasses• Gloves to protect againstsharp edges• Wood block• HammerREMOVE HANDLES AND TRIM• Open the door to 90°. Remove the 6 Phillips headscrews from the door handle.• Remove handle. Retain all screws.• Remove 6 screws holding trim. Lift off trim.Retain screws.STEP 1 INSTALL PANELS• Remove protective film from appearance panel.• Slide panel into the door trim.• If installing stainless steel panels, first slide fillerpanel into the door trim, then slide stainless panelinto the trim.• If necessary, tap with a wood block until panel slipsunder the hinge side trim.• There are two sets of holes in the handle side trim.Replace side trim by installing the original screwsin the FRONT screw holes.• Secure the handle to the door using the REARscrew holes.STEP 2Use Rear Holesto Secure HandleUse Front Holesto Secure Trim

/ 2

Related manuals for GE ZPBS360