GIGAMEDIA GS200 Series Quick Installation Manual
  |
NETWORKING EQUIPMENTGGM GS200QUICK INSTALLATIONGUIDEwww.gigamedia.net SMART SWITCH GS200 SERIESPACKAGING CONTENTThis guide gives step-by-step instructions for setting up all GIGAMEDIA Smart Switch GS200 series. Open the shippingcarton and carefully unpack its contents. Please consult the packing list from the User Guide to make sure all items arepresent and undamaged. Should it miss any item, please contact the GIGAMEDIA support team.MANAGEMENT OPTIONSThe GIGAMEDIA GS200 series Smart Switch can be managed by using Telnet. You can also choose the Web-basedManagement GUI, available through a Web browser. Should you want to use a SNMP-Based management tool, pleasebe advised that the SNMP feature is disabled by default.Each switch must be assigne dits own IP address. Furthermore, the PC should have an IP address in the same range asthe Smart Switch.WEB-BASED MANAGEMENT GUI1. Connect your Ethernet cable to any of the Gigamedia GS200 Smart Switch front panel ports.2. To login and configure your product, the PC must have an IP address in the same range as the Smart Switch. Thedefault GIGAMEDIA GS200 Smart Switch IP address is 192.168.2.1, so your PC should have an IP address like192.168.2.x (« x » is a number between 2 and 254) and a subnet mask of 255.255.255.0.3. Open your web browser and http://192.168.2.1 (factory-default IP address) in the address box.4. Once the logon box appears, enter the default username and password:a. Default username = adminb. Default password = system(please change your password after your first connexion)• 1 x GIGAMEDIA Smart Switch GGM GS200• 1 x Quick Installation Guide• 1 x Power cord• Rackmounted kitBEFORE ANY CONFIGURATION OF YOUR SMART SWITCH GGM GS200Please observe the following precautions before the Smart Switch installation:• Install your Smart Switch in a cool and dry place. Please refer to the Technical Specifications for the acceptableoperation temperature and humidity ranges.• Install the Smart Switch in a site free from vibration, dust and direct sunlight.• Leave enough space on the left and right side of the Smart Switch for ventilation.• Ensure that the power cable is firmly inserted into a suitable power outlet.FEATURES (DEPENDING ON MODEL)• From 8 to 48 Gigabit Ethernet auto-sensing RJ45ports, auto MDI/MDIX, PoE or non-PoE• Compliant with IEEE 802.3, IEEE 802.3u, IEEE 802.3x,IEEE 802.3ab, IEEE 802.3z standards• Support 10/100/1000Mbps auto-negotiation for fullduplex and half duplex• Support desktop and 19’’ rack mounted installationTECHNICAL SPECIFICATIONS• Standards: IEEE 802.3, IEEE 802.3u, IEEE 802.3x, IEEE802.3ab, IEEE 802.2z, IEEE802.3az• Performance: Store and Forward mode, non-bocking• L2/L2+ features: LACP, QoS, VLAN, port-mirroring,IGMP, STP/RSTP/MSTP, ERPS (G.8032), ACL, Dualimage, etc.• Operating temperature: 0 °C ~ 60 °C• Storage temperature: -20 °C ~ 70 °C• Working humidity: 10 % ~ 90 %, non-condensing• Storage humidity: 5% ~ 90 %, non-condensingINDICATOR INSTRUCTIONINDICATOR STATUT DESCRIPTIONSYS Green LED ON Working normallyGreen LED blinking Working normallyGreen LED OFF Abnormal working or Power offPoE(For PoEcompatiblemodel only)Yellow LED ON PoE device connected, working normallyYellow LED blinking Short circuit or current overloadYellow LED OFF No PoE device connected or Power offLINK Green LED ON Data under transmissionGreen LED blinking Connection OK and data sent / receivedGreen LED OFF No device connectedSFP UPLINK Green LED ON Data under transmissionGreen LED blinking Connection OK and data sent / receivedGreen LED OFF No SFP module connectedTECHNICAL SUPPORT (OUTSIDE FRANCE)• Technical self-service portal GIGAMEDIA: http://support.gigamedia.netDirective WEEEThis product is covered by the WEEE II Directive (Directive 2012/19 / EU). It should not be thrown in the trash or dumped. Substances in the product may behazardous to human health or the environment. Disposal may be done by returning the product to your dealer or leaving it a collection point provided forthis purpose.This product bears the CE mark which certifies its conformity with the directives LVD 2014/35/EU ; EMC 2014/30/EU and RoHS 2011/65/EU. Compliance hasbeen assessed in accordance with applicable standards in effect. |
Related manuals for GIGAMEDIA GS200 Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine