VR414115Included accessories1 x cast panhalf size2 x cast iron grill1 x lava stones1 x cleaning brushOptional accessoriesLV030000:Lava stonesInstallation accessoriesCKR420000:2 knobs, grill, blackCKR420010:2 knobs, grill, stainless steelVA420004:Connecting strip Serie 400, flush, shortVA420010:Connecting strip Serie 400, top, shortVA440010:Appliance cover Vario 400 seriesVario electric grill 400 series38 cmVR414115Two zones can be operated together orseparatelyCast pan, half size, for simultaneous frying andgrilling on two separate surfacesOpen cast grill, lava stonesPrecision crafted 3 mm stainless steelFor surface mounting with a visible edge or forflush mountingCan be combined perfectly with other Varioappliances of the 400 seriesHandlingControl knobs with illuminated ring, cookingzone and output level markings.Electronic control in 12 output levels.FeaturesCooktop, lava stone trough and greasecollecting insert from stainless steel.Two zones, each 1500 W, can be operatedtogether as a complete surface or each halfseparately.Two-part cast grill.SafetySafety shut-off.Pre-heat and residual heat indicator.Planning notesDepending on the type of installation(surface-mounted or flush-mounted, with orwithout an appliance cover), the specificlocation of the cut-out and the knob positionsmay vary.If installing with the appliance cover VA 440 takeinto account the additional space required forthe depth.If combining several Vario appliances of the 400series, a connection strip VA 420 must beplaced between the appliances. Depending onthe type of installation, the correspondingconnection strip must be provided.The bearing capacity and stability, in the case ofthinner worktops in particular, must besupported using suitable substructures. Takeinto account the appliance weight and additionalloads.Additional instructions for flush mounting:Installation is possible in worktops made ofstone, synthetics or solid wood. Heat resistanceand watertight sealing of the cut edges must beobserved. Concerning other materials pleaseconsult the worktop manufacturer.The groove must be continuous and even, sothat uniform placing of the appliance on thegasket is ensured. Do not use discontinuouslining.The joint width may vary due to size tolerancesof the combinations and of the worktop cut-out.If installing several appliances in individualcut-outs allow for a division bar of minimum 50mm between the individual cut-outs.A minimum lateral clearance of at least 100 mmfrom adjacent heat-sensitive furniture or from thewall must be observed.Appliance can be snapped into the worktopfrom above.Appliance weight: approx. 25 kg.ConnectionTotal connected load 3.0 KW.Connecting cable 1.5 m without plug.2024-01-161 /