Gainsborough K209 Instructions Manual

Also see for K209: Manual

Gainsborough K209 Instructions Manual Manual pdf 1 page image

Set 6 Colour Changing Solar Stake LightsK209 v002: 21/10/22Please read and retain these instructions for future referenceThe EnterpriseDepartmentUK Head Office, 11 Bridge Street, Bishop’s Stortford, CM23 2JUTel: 0844 4824400*, Fax: 01279 756595www.coopersofstortford.co.ukEU address: D.S.B. LD, 160 Bd. de Fourmies, 59100 Roubaix, FranceTel: (+44) 1279 701269*UK Calls cost around 7 pence per minute plus your telephone company’s network access.Please check with your telephone supplier.ALWAYS POSITION IN DIRECT SUNLIGHTASSEMBLY INSTRUCTIONS / INSTRUCTIONS FOR USE:Unpack the components carefully. Please check all parts have beenremoved from the packaging.Note: Ground stakes are located inside the square stand. Pull out theground stakes before assemblyBefore using first timeAllow lamp to charge for at least 8 hours in full sunlight with the ON/OFF switch in the ONposition. The ON/OFF switch is located in the lamp lid. Once the batteries are fully charged, set the ON/OFFswitch to ON. If the lamp does not turn on after dark refer to Maintenance section.NOTE: In order to verify that the switch is correctly in the “ON” position, cover the solar panel with yourhand and light should turn “ON” automatically.Find an ideal Place for the Solar Light.Place the solar light in an area where it will receive direct sunlight for at least 8 hours per day. The number ofhours the light will illuminate is directly proportional to the hours of sunlight it receives. If the light is placedin a shaded area, it will not be able to fully charge and its illumination time will be limited. Do not place thelight near other outdoor lighting like porch or streetlights. These may fool the sensor and keep the light fromcoming on, or cause it to turn off automaticallyTo easily insert stakes into the ground, it is recommended to wet the ground first. To avoid damaging gardenstakes when inserting into the ground, select a spot in soft, rock-free soil. Insert the base of the stake firstthen gently insert the rest of the stake into the base. DO NOT push directly against the solar cell or theornament housing containing the actual LED light.Dimensions(H) 35.5 x (W) 8 x (D) 8cmMaterial: Plastic• EACH HAS A COLOUR CHANGING LED INSIDE (LEDS NOTREPLACEABLE)• THE LIGHTS AUTOMATICALLY ILLUMINATE AT DUSK AND GOTHROUGH A COLOUR CHANGING CYCLE OF YELLOW, PURPLE,GREEN, BLUE AND RED TO CREATE A LOVELY LIGHT SHOW• ADDS SOME COLOUR AND FUN TO YOUR GARDEN• BUILT IN SOLAR PANEL SO NO CABLES• LINE PATHS, FLOWER BEDS, DRIVEWAYS ETCBattery: 1.2V AAA NI-MH 100MAH

/ 2

Related manuals for Gainsborough K209