Garmin 10 Install Manual
Also see for Mobile 10: Owner's manualSet up and goQuick start manualQuick start guide
    |
The GMS 10 Network Port Expander lets you connect more than two chartplottersand other Garmin marine network devices to share data. Simply connect one end of thenetwork cable to your Garmin marine network device and connect the other end of thenetwork cable to the Expander. Then, your Garmin marine network devices will be ableto share information such as weather, mapping, and sounder data as well as positioninformation.Contents• GMS 10 Network Port Expander (#010-00351-00)• Garmin marine network cable (#320-00227-00)• 7-pin power cable (#320-00023-05)• Grommet (#252-00129-00) Use the grommet to cover holes you drill for cables.• Optional mounting hardware kit (#K00-00123-00)Use the kit only if you cannot mount the Expander by using the factory-drilledholes. The kit contains two brackets with two screws/nuts per bracket. Use thescrews and nuts to attach the bracket to the unit. Screws to secure the Expander toyour boat are not included.Selecting a proper mount locationMount your Expander in a location that is away from heavy foot traffic and where thenetwork cables can easily reach your Garmin marine network devices and the Expander.If you foresee purchasing an additional Expander as you add Garmin network devices,make certain you have enough space to mount two Expanders near each other. Before youmount the Expander, consider the length at which the network cables will extend whenplugged in to the Expander and allow for this extra space. If you select a mounting loca-tion that prevents you from using the Expander’s factory-drilled holes, use the bracketsincluded in the optional mounting kit. (Instructions are included in the mounting kit.)Connecting the cable to the network port1. Unscrew the weather cap from a network port by turning the cap counterclockwise.2. Connect the network cable to the network port by aligning the cable head with the openingof the network port. Use the black arrow on top of the cable head as an alignment guide.3. Tighten the cable cap to prevent the cable from vibrating loose.GMS 10 Network Port Expander Instructions7-pin power cableconnectornetwork portsweather capsLED indicatorlights |
Related manuals for Garmin Mobile 10
manualsdatabase
Your AI-powered manual search engine