2. Attach the bike mount securely using two cable ties.Note: Make sure the cable ties are threaded through both partsof the bike mount.3. Align the Edge with the bike mount so that the unit is vertical.4. Slide the unit left until it snaps into place.To release the unit:Press down on the release lever, and slide the unit to the right.➊ Charge the Battery1. On the back of the Edge, pull up the weather cap from themini-USB port. Make sure that this area is completely dry toprevent corrosion.2. Plug the mini-USB end of the charger into the mini-USB port onthe unit.3. Plug the A/C charger into a standard wall outlet. Charge theEdge for at least 3 hours before using. When the battery iscompletely charged, it can run for approximately 12 hoursbefore recharging.➌ Configure the EdgeWhen you first turn on your Edge, the following setup screens appear.Follow the on-screen instructions.To configure your Edge:➋ Mount the EdgeYou can install the bike mount to the stem or handlebars. The steminstallation (shown here) provides a more sturdy location. Make surethat the Edge is facing up for the best GPS reception.To install the Edge on your bike stem:1. Place the wedge on the bike stem, and then place the bikemount on the wedge. Make sure the release lever is on the left.For horizontal bars: Separate and remove the top part of themount, turn it 90 degrees, and replace. Continue with step 2.For bars with a diameter less than 1 in (25.4 mm): Placethe additional rubber pad under the bike mount to increase thediameter of the bar. The rubber pad also keeps the mount fromslipping. Continue with step 2.Getting Started1 power• Press and hold to turn unit on/off.• Press to turn backlight on/off.2 mode• Press to switch modes.• Press to return to the previous page.3 reset/lap• Press and hold to reset the timer.• Press to create a new lap.4 start/stopPress to start/stop the timer.5 up/down• Press to highlight options.• Press to scroll through menus and data fields.• Press to adjust contrast when on the Satellite page.6 enterPress to select options and to acknowledge messages.Note: If the Edge locks up, press mode and reset/lap simultaneouslyto reset the unit.������������������������������� ��� ������123 46 5mini-USB port underweather cap➍Acquire SatellitesAcquiring satellite signals may take 30–60 seconds. Fortroubleshooting information, refer to the owner’s manual.To acquire satellite signals:Go outdoors to an open area. Press and hold thePower button to turn on the Edge.On the Satellite page, the available satellites areflashing while the Edge searches for satellitesignals. Acquired satellites and each correspondingbar below change to solid. The GPS accuracyappears at the top of the page.Wait while the Edge searches for satellites. For bestreception, make sure the Edge is facing up. Standstill in an open area, and do not begin moving untilthe Satellite page disappears. After the Satellitepage disappears, you can begin your ride.Screens 4 and 5apply to Edge 305only.1 2 34 5release lever wedge(optional)bike mount����release levercable ties