GC™ 200 IP MARINE CAMERAINSTALLATION INSTRUCTIONSMounting ConsiderationsWARNINGSee the Important Safety and Product Information guide in the product box for product warnings and otherimportant information.You can mount the camera upside-down or sideways. You can reverse the camera image to use in rearviewmode. See your chartplotter owner's manual for instructions.NOTE: You must update your chartplotter software to setup and view the camera feed on your chartplotter.• You must mount the camera in a location where it is not submerged, does not present a hazard in doorwaysor walkways, and cannot be damaged by docks, pilings, or other pieces of equipment.• You should mount the camera in a location strong enough to support the weight of the device and where youcan remove the camera.• You should mount the camera so the LED is visible and the cables can be connected easily.• To avoid interference with a magnetic compass, do not mount the camera closer to a compass than thecompass-safe distance value listed in the product specifications.• You should test the camera in the selected location before you permanently mount the camera.• You can use the Garmin®Power Module to help make the installation easier. The Power Module uses asingle camera cable instead of separate power and ethernet cables. This is especially beneficial when thecamera is located far away from other electronics, such as near the bow or on a mast.Tools Needed• Drill and 2 mm (1/16 in.) drill bit• Pozidriv®screwdriverGUID-95567C20-B681-4E56-B4B1-71CF15B4972A v2August 2021