Garmin GHC 50 Installation Instructions Manual

Garmin GHC 50 Installation Instructions Manual Manual pdf 1 page image

GHC™ 50INSTALLATION INSTRUCTIONSImportant Safety InformationWARNINGFailure to follow these warnings, cautions, and notices could result in personal injury, damage to the vessel ordevice, or poor product performance.See the Important Safety and Product Information guide in the product box for product warnings and otherimportant information.CAUTIONTo avoid possible personal injury, always wear safety goggles, ear protection, and a dust mask when drilling,cutting, or sanding.To avoid possible personal injury or damage to the device and vessel, disconnect the vessel's power supplybefore beginning to install the device.To avoid possible personal injury or damage to the device or vessel, before applying power to the device, makesure that it has been properly grounded, following the instructions in the guide.NOTICEFor the best possible performance, the device must be installed according to these instructions.When drilling or cutting, always check what is on the opposite side of the surface to avoid damaging the vessel.Tools Needed• Drill and drill bits◦ Preparing the surface for cutting:9 mm (3/8 in.) bit◦ Installs using wood screws:2.5 mm (3/32 in.) bit◦ Installs using the nut plate:3.5 mm (9/64 in.) bit4 mm (5/32 in.) bit• #2 Phillips screwdriver• Jigsaw or rotary tool• File and sandpaper• Marine sealant (recommended)GUID-9CEF40E7-A1D9-42A3-9EB1-DF9CF3B47115 v1April 2022