Garmin Panoptix LiveScope LVS32 Installation Instructions Manual

Also see for PANOPTIX LIVESCOPE GLS 10: Installation instructions

Garmin Panoptix LiveScope LVS32 Installation Instructions Manual Manual pdf 1 page image

PANOPTIX™LIVESCOPE™INSTALLATION INSTRUCTIONSImportant Safety InformationWARNINGSee the Important Safety and Product Information guide in the chartplotter product box for product warningsand other important information.You are responsible for the safe and prudent operation of your vessel. Sonar is a tool that enhances yourawareness of the water beneath your boat. It does not relieve you of the responsibility of observing the wateraround your boat as you navigate.CAUTIONFailure to install and maintain this equipment in accordance with these instructions could result in damage orinjury.To avoid possible personal injury, always wear safety goggles, ear protection, and a dust mask when drilling,cutting, or sanding.NOTICEWhen drilling or cutting, always check what is on the opposite side of the surface to avoid damaging the vessel.To obtain the best performance and to avoid damage to your boat, you must install the Garmin®deviceaccording to these instructions.Read all installation instructions before proceeding with the installation. If you experience difficulty during theinstallation, go to support.garmin.com for more information.Software UpdateYou must update the Garmin chartplotter software when you install this device. For instructions on updatingthe software, see your chartplotter owner's manual at support.garmin.com.Tools Needed• Drill• 4 mm (5/32 in.) and 3.2 mm (1/8 in.) drill bits• Masking tape• #2 Phillips screwdriver• Marine sealant• 32 mm (1 1/4 in.) hole saw (optional)• Cable ties (optional)GUID-8ABE5659-3192-4519-8A48-66421E004620 v5March 2021