![Garmin RV-BBT602 Installation Instructions Manual Manual pdf 1 page image](https://manuals-archive2.s3.amazonaws.com/5093809/c4837f2db02185f89bce8130cc1a914a1f.jpg)
RV-BBT602Installation InstructionsImportant Safety InformationWARNINGSee the Important Safety and Product Information guide in theproduct box for product warnings and other importantinformation.NOTICEFailure to follow these cautions could result in damage to thevehicle or poor product performance.This device must be installed according to these instructions.Disconnect the vehicle's power supply before beginning to installthis product.Before applying power to this product, make sure it has beencorrectly grounded according to the installation instructions.You must read all installation instructions before beginning theinstallation. If you experience difficulty during the installation,contact Garmin®Product Support.Connector IdentificationItem Connector NotesÀ Microphone input 3.5 mm mono miniplug for the hands-free microphone (included)Á Video in Composite video RCA connector Zone 1 line out Left, right, and subwoofer RCAconnectorsà Wiring harnessconnectorsThe wiring harnesses are not included.See (Pin Identification, page 1) forpinout information.Ä Zone 2 line out Left, right, and subwoofer RCAconnectorsÅ Aux 1 input Left and right RCA connectorsÆ Zone 3 line out Left, right, and subwoofer RCAconnectorsÇ Camera audio input orAux 2 inputLeft and right RCA connectorsÈ Zone 4 line out Left, right, and subwoofer RCAconnectorsItem Connector NotesÉ USB (500mA) Reserved for manufacturer useCompatible only with low-current(<500 mA) USB devicesUSB (2.1A) Interfaces and charges supportedsmartphones and USB devicesCAN BUS 1 Connects to an NRX wired remotecontrol using an adapter (soldseparately)CAN BUS 2 Reserved for vehicle integrationDigital Audio Broadcast(DAB) portConnects to a compatible FUSION®DABmodule and antennaAM/FM antenna Connects to the vehicle antenna. Theincluded adapter may be required.Pin IdentificationYou can use this pinout diagram and table to create a wiringharness for this device.Pin FunctionÀ Speaker: zone 2 left positive (+)Á Speaker: zone 2 left negative (-) Speaker: zone 1 left positive (+)à Speaker: zone 1 left negative (-)Ä Speaker: zone 1 right positive (+)Å Speaker: zone 1 right negative (-)Æ Speaker: zone 2 right positive (+)Ç Speaker: zone 2 right negative (-)È Ignition switch positive (+12 Vdc input)É Power ground (-)Amplifier signal (+12 Vdc output)DimNot applicablePower input positive (+12 Vdc input)Backup camera (+12 Vdc to trigger)Tel/mute (ground to trigger)Connecting a FUSION NRX Remote ControlYou can connect a FUSION NRX remote control (not included)to the stereo dock using an adapter cable (not included). Youcan purchase an NRX remote control and the required adaptercable from your FUSION dealer.You can connect up to three NRX remote controls directly to thestereo dock without connecting them to an additional powersource. If you want to connect more than three NRX remotecontrols to the stereo dock, you must connect them to anadditional power source. See the instructions provided with theremote control for more information.1 Install the NRX remote control by following the instructionsprovided with the remote control.2 Repeat the previous step for each additional NRX remotecontrol you want to install.3 Route the network cable from the NRX remote controlnetwork to the location of the stereo dock. June 2017190-02206-03_0A