Step 4: Follow Your RouteFollow the route to your destination using the Map page. As you travel, your c330 guides you to your destination with voiceprompts, arrows on the map, and directions at the top of the Map page. If you depart from the original route, your c330 voiceannounces that you are off-route and then provides new route instructions.Your route is marked witha red line.Follow the arrows as youtake turns.A checkered flag marksyour destination.Read the drivinginstructions at thetop of the page.Step 2: Configure Your c330The first time you turn on the unit, follow the on-screen instructions to set up your c330. You only have to do this once.Step 3: Find Your DestinationTouch Where to? Select a category.Touch the arrows to seemore categories.Select a destination.Touch the arrows to seemore places.Touch . Enjoy the route!StreetPilot®c330quick reference guideWARNING: For use in vehicles, it is the sole responsibility of the owner/operator of a vehicle with the c330 installed to place and secure the device so it will not interfere with the vehicle operating controls andsafety devices, obstruct the driver’s view of driving conditions, or cause personal injury in the event of an accident.NOTICE TO STATE OF CALIFORNIA DRIVERS: California Vehicle Code Section 26708 (a) (1) provides that drivers in California should not use suction mounts on their windshield or side or rear windows.Other Garmin dashboard or friction mounting options should be used. For available accessories, refer to the Garmin Web site at www.garmin.com. Also, refer to the Owner’s Manual for instructions on using theincluded mounting disk with the suction cup mount.Step 1: Mount Your c330Place the suction cup on yourwindshield.Fit the bottom of your c330 intothe cradle of the suction cupmount.Tilt your c330 back until itsnaps in place.Flip the lever back, towardthe windshield.Tension knobTo ensure a tight grip, clean and dry your windshield before you mount the suction cup. Plug the cable into a receptacle inyour vehicle. If necessary, use the tension knob to loosen or tighten the tension in the mount to improve your viewing angle.Your unit will turn on automatically if you have started your vehicle. To manually turn on your c330, press and hold thePower button on the side of the unit. Refer to the image on the back of this sheet.