OPERATING INSTRUCTIONS:SEA HUNTER MARK llThe Sea hunter Mark ll is an extremely versatile detector, offering four (4) mounting/stemarrangements to suit your search needs.• Long stem with the housing mounted above the stem.• Long stem with the housing mounted below the cuff assembly.• Short stem with mounting as above for diving.• Belt mounting leaving the stem free of housing. This may be used with either stemconfiguration.ASSEMBLY INSTRUCTIONChoose the desired operating stem/housing configuration and assemble the stem.1. Compress the button ends of the spring clip and insert, button end first, into the lower stemof the detector so that the button ends pop out of the holes. This will enable the lower stemassembly to be attached to the upper stem and the over all length of the detector adjustedfor a comfortable operating length.2. Attach the lower stem to the searchcoil by inserting the two rubber washers into the stemand slipping the searchcoil onto the stem. Insert the threaded bolt through the holes andhand-tighten the two knobs.3. Install the upper stem to the lower and adjust for the most comfortable operating length.4. Wrap the searchcoil cable snugly about the stem with the first turn of the cable over thestem.5. Insert the cable connector into the connector on the detector housing and hand-tightensecurely. Do not over tighten. Ensure that the searchcoil connector is clean and the o-ringis lubricated. If necessary use a very small amount of silicon grease or petroleum jelly. Donot coat the connector pins with lubricant.6. Perform a battery test by turning the detector on. Note the number of audio tones thatoccur. Pass a metal target such as a coin beneath the searchcoil to confirm metaldetection.CONTROL FUNCTIONSFamiliarize yourself with the detectors controls. Their basic functions are given here. Howthey can help you find treasure is explained in the Operating Instructions of this Manual.Power/ Depth:• Turns the detector on. The batteries are checked automatically and audibly each timethe detector is turned on.• Turns the detector off.• Selects either of the two (2) search modes.