GenConnex EU2200i Propane kit Assembly Instructions Manual
Step 1A - Remove skinsStep 1B - Remove gas tank & drain lines= ++1a-1 Remove choke label(Propane does not use choke).1a-3 Remove gas cap byremoving cotter snap pin.1a-4/5 Unscrew and tilt out front bezel (4 screws). 1a-6 Remove rear bezel (4 screws).1a-7/8 Remove two handle screws. 1a-10/11 Remove lower skinsbolts (2 10mm bolts).1a-12 Remove screw near pull handle. 1a-13 Gently remove skins.1b-1 Remove fuel line clamp atbottom of gasoline tank AFTERFULLY DRAINING GASOLINE!1b-2 Remove fuel tank by separatingplastic frame at very top and gently liftingup on tank.1b-3/4 Remove fuel drain & vent tubes (3 tubes). 1b-5 Remove 2 fuel tank bottom bumpers.Before Starting: DRAIN OUT ALL GASOLINE FROM TANK AND FLOAT BOWL AND DISPOSE OF SAFELYGenconnex® Genconnex® Honda EU2200iPropane kitAssembly InstructionsVersion 2.031a-9 Remove lower trim (thisside only) by prying off with fingeror flat blade screw driver.Step 1C - Remove air cleaner boxStep 1D - Remove chokeStep 1G - Remove carburetor & bolts & ground screwStep 1F - Remove gasoline lines & pump1c-1/2/3/4/5/6 Remove air cleaner unit by first removing outer cover then one inner 8mm hex bolt, vent tube, then two outer 8mm hex nuts then slide off air cleaner assembly.1d-1/2/3 Remove pressed-in choke plate by pulling outward with pliers (use force),then turn handle full right then pulling up.1f-1/2/3/4/5 Remove gas pump & line to carburetor, engine vent below carburetor, then remove gas lines from plastic holders (leave bracket in place for new fuel line)and then remove two screws holding pump to frame. Then remove fuel feed tube below pump going two switch. This should free up pump for removal.1g-1/2/3/4 Remove two 8mm long bolts (to be replaced later with longer bolts) holding carburetor to engine by removing two shorter 8mm flange bolts.Remove ground screw and save..Step 1Dis-assemblyEngineered to the next level.Genconnex®35 Pond Park Road, Hingham, MA 020431-800-341-0792#1 Phillips dead screw driver#2 Phillips head screw driverflat head screw driver8mm socket10mm socket3/8” socketpliers or channel locksmicrowave oven or boiling water5/32” Allen head socket or wrenchCopyright 2020 New England Gen-Connect LLC. All rights reserved.1a-2 Remove access door.https://genconnexdirect.net/liturature.htmOn-Line PDF |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine